This Marshall Electronics Dual Uni Battery Mount is compatible with the Marshall Electronics V-LCD56MD and V-LCD70MD monitors. It attaches on the back of the monitor via a baseplate that's supplied with the monitor. It supports two Canon LP-E6 batteries with hot-swap functionality and uses only one battery at a time. Connection to the monitor is via an integrated cable with a JST connector. The required baseplate can also be purchased separately (model # 0032-1303A).

Compatible with Marshall Electronics V-LCD56MD and V-LCD70MD Monitors

Related Questions and Answers

Q: 1. will this work with bolt6 LT 750?

A: Yes, the Teradek Dual Direct Mount Battery Plate for L-Series and LP-E6 Batteries will work with the Bolt LT750. It is compatible with: Bolt 1000/3000 XT Transmitters Bolt 500 XT Transmitters and Receivers Bolt XT Sidekick All Non-4K Bolt LT Models Please Note: This battery plate will not work on Bolt 1000/3000 XT Receivers.

Q: 2. How does this plug in to the monitor?

A: Hi, it plugs in to the mini 4pin XLR power connector on the back of the monitor.

Q: 3. Is this plate also compatible with the Ace 800?

A: It is not. You would need BH #TE110759 instead, which offers the proper LEMO connection for the Ace 800. https://bhpho.to/3aqVMvM

Q: 4. Is this compatible with the SWIT S-8970 DV Battery?

A: Yes

Q: 5. Will this work with the Teradek Ace 500?

A: No, this is the battery plate that is compatible with the Teradek Ace 500: https://www.bhphotovideo.com/c/product/1493877-REG/teradek_11_0848_ace_battery_plate_for.html

Q: 6. is the out jack 5.5x2.1mm? I'd like to use my cable because my cage won't accept the right angle 2.5x.07mm plug.

A: These out put jacks are 2.5mm. If you need to find the right solution to use a 2.1mm jack, you can contact use directly, we will need to know few details to steer you in the right direction contact our customer service atsales@indiproco.com

Q: 7. The plate comes with a power connector with two male jacks - a 5.5x2.1 and a thinner one. Does anyone know the dimensions?

A: Unfortunately, the manufacturer does not provide explicit details for the requisite dimensions. For your convenience, the following link will bring you to the manufacturer's support page for accurate and up to date support: https://bit.ly/2Zrj2VE

Q: 8. How long will it run on a single battery?

A: That will depend on the battery you use. This can work with LP-E6 batteries, which come in only one size or NP-F style batteries that range in size. If you are using the smallest option for an LP-E6 you might get 90 minutes or so. If you use a full size NP-F970 you could get hours of run time.

Q: 9. Once I connect the JST connectors, where am I supposed to tuck them into? The gap inside the battery plate, or the gap inside the Bolt 500XT transmitter?

A: As other users have defined, you can press the cable from the transmitter into the gap and align the connector to allow the battery plate to press into the opening. It's going to be a tight fit, but it should work.

Q: 10. Will a NP-F970 battery fit in this plate?

A: Yes, this plate accepts Sony NP-F style batteries. You will be able to use an NP-F970 with it.