Safeguard a device from surges and other power fluctuations with the Single-Outlet Surge Protector from MinuteMan. Designed to defend a device from voltage spikes, power surges, and other electrical hazards, this single-outlet protector features metal-oxide varistor or MOV technology. When excess voltage trips the MOV, extra power is diverted to the ground, preventing that excess voltage from frying your device. Additionally, high-frequency capacitors ensure minimal electro-magnetic or radio-frequency interference to your connected device. Finally, in addition to safety shutdown technology for more secure operation, the MinuteMan Single Outlet Surge Protector utilizes LED indicators to visually alert you when your device is grounded and protected.

Single Grounded Outlet    MOV Technology    Safety Shutdown Technology    High Frequency Capacitors    LED Indicators

Related Questions and Answers

Q: 1. What's the interior dimensions of the 1400 case with the Trekpak wall installed?

A: While Pelican does list the interior dimensions of the Pelican 1400 Protector Case as measuring 11.8" × 8.9" × 5.2", they do not list the measurement with the TrekPak Divider Kit for Pelican 1400 Small Protector Case installed in place. They do state the panels are 7/16" (1.1 cm) thick, so as there are two perimeter wall panels, I would estimate the size with the panels as 10.9" x 8" x 4.3" in size.

Q: 2. Hi. I'm trying to fit my Canon 1DX Mark II standing up with a 24-70 f2.8 III attached so wondering if it will fit this case? Tried with a Nanuk 935 with dividers but the top of the camera was hitting the lid when closing. Thank you in advance for your help.

A: You can fit your camera in the case but not on end, you will have to lay down with the lens attached.

Q: 3. Is this protector useable for any NIKON flash accessory shoe. More specifically, the NIKON SB600 or SB400?

A: Yes, the Vello HSC-NF Protector for Nikon Accessory Foot will fit the Nikon SB400 and SB600 flashes.

Q: 4. Has anyone flown with this insert? I'm concerned the TSA will say something about the metal pins that hold the dividers together.

A: Yes, I did very often domestic and Internationally and never had any questions or problems at all. I have a very few dividers and all the metal pins are lined up in one corner.

Q: 5. Will this protector fit on the new GR IIIx?

A: Due to the camera being recently announced, we have not yet been informed if the dimensions of the lens will differ and if this protector will fit the new GR IIIx. When more information is available, we will update this page and provide information regarding its fit.

Q: 6. Can this lens protector be used while taking photos underwater with the TG6?

A: No, the cap can not be used on the TG6 while under the water.

Q: 7. can an impact autopole work as well?

A: Yes this base is also compatible with Impact Varipoles.

Q: 8. Thanks for all the responses to my last question, I wanted to know what the actual all thickness is on these things? trying to figure out if the 1510 model will be big enough

A: The perimeter piece measures around 5/8 thick and the deviders are 3/8 .

Q: 9. what are the pockets size?

A: The pocket size is adjustable, you can make them any size you like.

Q: 10. Will this fit well in the Nanuk 950?

A: No it will not fit. This is made specifically for the Pelican 1560.