Designed for voice, data, and security uses, the blue CAT6 Twisted Pair Networking Cable from Bolide Technology Group adheres to the Cat6 standard and comes in a length of 1000 feet. This cable is marked by the foot and packaged in an easy-to-pull box to help simplify installation. Underneath the cable's PVC jacket is copper-clad aluminum wire that has been sparker tested up to 1200V. Protection is provided by a limited one year warranty.

Cat6 Standard    1000' Length    PVC Jacket    Copper-Clad Aluminum Wire    Sparker Tested: 1200V

4-pair unshielded twisted pair UTP Ethernet LAN cable

23AWG network & ethernet cable

Conductor: 1/0.52±0.008mm
PVC Jacket Outside Diameter: 6.0±015mm

A Category 6 cable, commonly referred to as Cat 6, is a standardized twisted pair cable for Ethernet and other network use

Foot-marked cable is packaged in an easy-to-pull box for easier installation

Related Questions and Answers

Q: 1. Are there access holes on each end for cables, like https://www.bhphotovideo.com/c/product/684128-REG/Vaddio_535_2000_291_Drop_Down_Ceiling_Mount.html?

A: Yes, The Bolide Technology Group Heavy Duty In/Out Adjust Bracket does have cable access cutouts on the base and the end of the pole where the camera mounts.

Q: 2. What is the diameter of the bulbs in the middle of the cable?

A: The cable thickness is interesting but the information that is really needed is the size of the two large oblong rounded cylinders ( I call them bulbs) in the middle of the cable length. They appear to be about 3 times the diameter of the rest of the cable. This is what determines the size of the conduit or holes that are needed to pass the cable through.

Q: 3. What type of junction box does this attach to? Round? Octagonal? Square?

A: The Bolide Technology Group 78" Heavy Duty In/Out Adjust Bracket (BH #BOBP002178) is not designed to accommodate a junction box. It is fitted with a standard 1/4"- 20 male camera mount.

Q: 4. Would i need the receiver if i have a device that supports HDBT?

A: No, the Kramer PT-571 HDMI over Twisted Pair Transmitter will allow you to output HDBT signals directly to the device you are using that has HDBT input. You do not need a receiver.

Q: 5. Does this unit pass HDR also?

A: No HDR pass-through is defined on this product.

Q: 6. Is there any audio delay or sync issues with audio and video?

A: There should be no audio delay or sync issues with this unit. It also will have a very low latency.

Q: 7. Will this support 1920x1200?

A: System Range : 1080i,1080p, at different distances and BC-DGKat 524.

Q: 8. is the extender IP based? is it able to be fed through a switch in its own VLAN? or does it have to be a direct connection on both ends?

A: It is not IP traffic, it is HDbaseT over ethernet cable. https://en.wikipedia.org/wiki/HDBaseT

Q: 9. How important is shielded cable? I'm wondering about our existing unshielded 250ft cat6 run.

A: Shelled cables are recommended as they will help protect against any potential power surges when connected to the Kramer TP-580TXR Extended Range HDBaseT Twisted Pair Transmitter, but they are not required.

Q: 10. Does this have standard 1/4"-20 mount at camera end?

A: The Bolide Technology Group 78" Heavy Duty In/Out Adjust Bracket BH #BOBP002178 is equipped with a 1/4"-20 standard camera mount.