Light your driveway, sidewalk, courtyard, or any open space using renewable solar energy with the Solar + LED Floodlight with Remote Control from Wagan Tech. Just like a streetlight, this 15" lamp turns on automatically at dusk and produces a peak output of 3000 lumens. It works in two modes, motion detection or timer, and is easily managed with the simple remote control. Wagan's Adaptive Light Technology provides a runtime up to ten nights on a single charge. The floodlight is designed to be mounted on a wall or a user-supplied pole, and no electrical wiring is required, just a few basic tools for mounting.

The fully self-sufficient Solar + LED Floodlight comes on at a user-selected level between 20 and 50% of peak, but jumps up to full power when motion is detected within 16 feet, such as a person walking by. The remote can be used to set the timer or to simply turn the light on and off. It takes ten hours of full sunlight for the solar panel to charge the lamp's internal, 3.7V, 12Ah battery. Naturally, the floodlight is designed to be weather resistant and carries an IP65 dust and waterproof rating.

Peak Output: 3000 Lumens    Auto On/Off or Remote Control    Sensor Boosts Light When Motion Detected    Detection Range: 6-26'    Self-Contained, No Wiring Needed    Mounts on Pole or Wall    120° Beam Angle    10-Hour Charge Time in Full Sun    Runtime: Up to 10 Nights    3.7V, 12Ah Battery

• 3000 Lumens peak brightness from 60 LEDs
• Comes on at dusk, goes off at dawn
• Runs below full power but goes to 100% when motion is detected
• Also use in timer mode
• Simple remote control

• Monocrystalline 6.5W solar panel, 17% efficiency
• Panel charges 3.7V, 10Ah lithium battery
• 10 hours charge time at full sun
• Up to 10 nights of runtime
• Overcharge and over-discharge protection

• IP65-rated weather resistant
• Mounts on wall, pole, tree, etc.
• Installation height: 9-15' / 3-5 m
• No electrical wiring required

Related Questions and Answers

Q: 1. Does this work with the UL150?

A: No, the Godox RC-R9 is not compatible with the Godox UL150. The correct remote control is the Godox Remote Control for UL150, VL150/200/300, LED1000D II, LED1000Bi II, BH #GORCA5I. https://bhpho.to/3puhjvd

Q: 2. Can the Nikon WR-1 function as an intervalometer?

A: Yes, the Nikon WR-1 Wireless Remote Control Transceiver has an intervalometer function built in.

Q: 3. Does the 2 light softbox kit come with the adequate speedrings to mount to the flood lights?

A: The Impact Qualite LED Flood 2-Light Bundle comes with two speedrings.

Q: 4. Does it turn on and off theNanlite PavoTube II 6C RGB LED Tube?

A: Yes, you can use Nanlite Nanlink 2.4 GHz Remote Control to adjust brightness on Nanlite PavoTube II 6C RGB LED Tube. To completely turn ON/OFF lights you will need to move the switch on the light.

Q: 5. Does this work the PavoTubes?

A: Yes, the following item will control the Nanlite or Nanlux light with a built-in 2.4 GHz receiver at distances up to up to 32 feet away.

Q: 6. Does this work with the z6

A: No, the Nikon ML-L7 Bluetooth Remote Control is not compatible with the original Nikon Z6 Mirrorless Camera. As an alternative one can use the Vello FreeWave Plus II Wireless Remote Shutter Release for Select Nikon Cameras, BH #VEFWPN (https://bhpho.to/3ECDR5m).

Q: 7. Does it work with Z9? B&H listed Z9 in the compatible cameras but Nikon says otherwise.

A: The Z9 is not compatible with the ML-L7--it has a different connector than the other Z-mount cameras. The Z9 can be triggered wirelessly using the Nikon WR-R11a Remote Controller plus the Nikon WR-T10 Wireless Remote Controller Transmitter: https://www.bhphotovideo.com/c/product/1598719-REG/nikon_4255_wr_r11a_wr_t10_remote_controller_set.html

Q: 8. Does this work with the Canon EOS R6?

A: Yes The Canon BR-E1 Wireless Remote Control can be used with the EOS R6. Plus many other wireless remot contro options are possible See page 644 of the Manual

Q: 9. Is there a compatible ring light that you could attach to this stand?

A: The Angler Bi-Color LED Ring Light (18"), BH # ANRLB18LED can fit on the included light stand in this Impact kit. https://bhpho.to/3nmO4Yw

Q: 10. Will it hold the shutter open in bulb mode for long exposures?

A: No this Canon BR-E1 Wireless Remote Control does not have a Bulb Mode option and only triggers the camera shutter at shutter speeds selected in the camera.