Suited to home, RV, van life, and many more applications, the ACOPower 20-Watt Monocrystalline Solar Panel collects renewable energy for charging 12-volt batteries and portable power stations. Pre-drilled for easy installation on a structure or vehicle, the panel is made with tempered glass that's been treated with antireflective coating, plus two layers of EVA film, a TPT backsheet, and an anodized aluminum frame—all designed to withstand snow loads of 5400 Pa and wind pressure of 2400 Pa. The junction box on the rear of the panel carries an IP65 water-resistance rating. The panel comes with a 3.2', 16 AWG cable with male and female quick connectors.

High 19.1% Efficiency    Reinforced-Aluminum Frame    Antireflective Coated Glass    Withstands High Snow and Wind Loads    Pre-Drilled for Easy Installation    3.2' 16 AWG Cable, M/F Quick Connectors    IP65-Rated Junction Box

Related Questions and Answers

Q: 1. I have a Norman 400B that I purchased about 10 years ago. Now, the battery will no longer hold a charge. Can I get just a replacement battery and are the new versions compatible with the older 400B?

A: Norman has not changed that in a very long time. This is the battery for the Norman 400B,Norman 812863 NiCad Battery for P400B, B&H # NOB400B MFR # 812863.Best would be for you to check with Norman to make sure your specific model has not been changed.a href= http://normanlights.com/contact.asp target= _blank http://normanlights.com/contact.asp./a

Q: 2. HI. I want to 202vf head for 220vac. Where can I found it?

A: The operating voltage would be dependent on the power pack which the head is plugged into. The following link shows the Speedotron power packs which we offer that are 220V compatible and will accept the 202VF flash head. http://bhpho.to/1Ta63j7

Q: 3. Can this be used with the canon eos 3?

A: The Watson NP-E3 NiMH Battery Pack (12V, 2000mAh) is only compatible with: Canon EOS: 1D 1D Mark II N 1D S 1Ds Mark II

Q: 4. I have 2 of these and one of them is not working correctly. they light on it just stays green when it plug a battery to it. is there something wrong with it?

A: There is nothing wrong .The green light indicates that the battery is fully charged

Q: 5. Can you place 1000w FCM bulbs into the fixture?

A: No, the Smith-Victor SL200 units can house a total of 600 watts each. Please review the following bulbs to get max output of 600 watts https://bhpho.to/40lGIYS

Q: 6. Is this lamp compatible with the Senso a4 powerpack?

A: Yes this flash head is compatible with the Broncolor Senso A4 power pack.

Q: 7. Is there any other compatible quick-release plate that has both the 1/4" and 3/8" screws for Komodo to prevent twisting?

A: Unfortunately there is no other quick-release plate that has both the 1/4" and 3/8" screws for the RED Komodo that is compatible with the Anton Bauer Titon Base Battery.

Q: 8. Does the head include the flash tube, modelling lamp and protective glass dome?

A: In the Box: Broncolor Unilite 3200 W/S Flash Head for Verso, Pulso, Topas, Grafit, Nano, Opus, Mobil Power Packs 3200 w/s flashtube (150004) 300W Modeling light with fuse (152004) 16.5' Head extension cable (154007) Protective cap 2 Year Manufacturer's Warranty excluding flashtube and modeling light It does not include a pack that is required for it to operate.

Q: 9. Does Watson supply a charger that will work with their NP-E3 battery equivalent? Or am I stuck tracking down a Canon NC-E2?

A: As of yet, there are no Watson chargers for the NPE3 battery. There may be one down the road. Keep checking our website for updates.

Q: 10. Does this come with any Ratio Plugs included?

A: The AA06B comes with two of ratio plugs, the AA06-PP5 and AA06-PP8 ratio plugs.