Use this chroma green Impact 6 x 7' Background v2 for portraiture, products, e-commerce, and general video or still photography. The chroma green color allows you to chroma key your own background into the shot in postproduction, so you can customize your video footage and cut production costs by reducing the need for expensive location shoots. This lightweight polyester muslin background features a 4" rod pocket that runs along its 6' width for background stand crossbars, and a see-through bag for easy identification, storage, and transport. The background can be machine washed separately in cold water.

Rugged Polyester Muslin    Ideal for Background Replacement    Machine Washable    4" Rod Pocket for Crossbar

Related Questions and Answers

Q: 1. Which stand is recommended to hang this up?

A: This stand can be used https://bhpho.to/2XmLCaE.

Q: 2. Are these muslins designed for 24' width or 24' in height (to be used as a wall to floor seamless)?

A: The sown in rod hanging looped over part of the fabric is on the 10' side. So, these are designed to hang on the rod with the 10' width. They then fall down 24' and drape onto the ground. You could also use spring clamps (#2 grip clips) to hang the fabric in any orientation you'd like. For example you could clamp the fabric so that it's 24' wide and 10' tall if you like. But it is designed to hang on the included rod and stands in a 10' wide 24' tall orientation... and since the stands only go up so far... there is quite a bit of overflow fabric that you can put on the ground.Hope this helps!

Q: 3. What is the width of the pole?

A: the horizontal pole is about 1 wide and the vertical stands are about 3/4 -1/2 inch wide.

Q: 4. Is this kit/bag appropriate to be checked at an airport?

A: It breaks down into its own bag that is small enough to go through.

Q: 5. Can the white side be used as a fill to bounce light?

A: Yes you could use the white side as a bounce.

Q: 6. How do you make the bars into the 6' across the top?

A: The top bar comes in three separate sections which allow for you to make it short or long. The whole setup comes apart easily and goes inside a nice little storage case. Best bang for your buck.

Q: 7. Can this product be used in portrait or landscape modes?

A: It can but not with this stand it needs two points of contact on top to hold it firmly.

Q: 8. I got this system along with a 10'x12 muslin background. What do you use to hold the muslim on the sides to make it seamles? A standard clip does not seem to work because there is a lot of space between the side bars and the muslim sides

A: We use several clamps like you can buy at Lowes or Home Depot. Youll need a few on each side. If there is too much gap youll need to get a shorter cross support beam . They make some that are adjustable. I would also recommend gaffers tape on the floor to tape the edges. Hope this helps.

Q: 9. Is the black side dark enough to be used as a negative fill?

A: You can use the back side as a negative fill.

Q: 10. I am looking at buying this to put a step and repeat banner on. Could a full 12' wide banner fit on the crossbar or should i make it around 11'? Would this handle the weight of a vinyl banner that length and 8 ' Tall?

A: I used a 12' x 8' banner on this stand recently and it worked out very well. I will reiterate what Joseph says, Use weights to keep this thing stable. I suggest the 5lb sand bags sold at B&H. These are cheap and I've got 8 or 10 of these as they come in handy to keep tripods grounded, light stands firmly planted, and backgrounds upright.