The 330mL PFI-2300 Magenta Pigment Ink Cartridge is a pigment-based ink compatible with the Canon imagePROGRAF GP-4000 and GP-2000 printers.

For imagePROGRAF GP-4000/GP-2000 Printers

Related Questions and Answers

Q: 1. What is the range of duration to complete the slide from end to end?

A: The fastest video slide when the GVM GP-120QD Motorized Carbon Fiber Video Slider (48") ion a level surface is between on average 8-12 seconds. Payload weight and could also be a factor in the speeds you achieve with the slider.

Q: 2. If you want to put the camera on a tripod, do you have to remove this grip?

A: Hi James, you have to remove this grip if you want to put the camera on a tripod. -Anthony

Q: 3. What is the package size?

A: The packaging information for the GVM GP-120QD Motorized Carbon Fiber Video Slider (48") are as follows: The package weight is 12.55lb and the dimensions (LxWxH) are 52 x 11.85 x 4.4".

Q: 4. How do you mount a go pro on this?? Also does the angle of the camera change or does it just move horizontally?

A: You will need to use a tripod mount adapter for GoPros. The slider just moves horizontally.

Q: 5. What is the vertical load capacity?

A: Payload at a 30 degree incline is reduced to 5.5lb, so at full vertical, this cannot exceed 3lb.

Q: 6. Will this work on the Sony a7RV?

A: No, Sony GP-X1EM Grip Extension will not work on the Sony's A7RV.

Q: 7. Would the new 13 Touch Bar MacBook Pro fit in the laptop compartment?

A: Yes, I have a 2016 MacBook Pro 13 that fits perfectly in the compartment

Q: 8. Does it fit the A7M3?

A: Yes it works and if you use peak design there is a way to rig it to work with tripod plate. It does help out when using heavier lenses to have pinky grip. Its all metal, super light too.

Q: 9. Is there a place to attach a hand strap on the extension?

A: The D ring on the bottom to tighten the nut would accomodate something like a Blackrapid strap. If you go this route I highly recommend adding an OP/TECH USA Uni-loop as a secondary connection between strap's mini carabiner and camera strap connection point on the camera body itself.

Q: 10. There are two little "pins" on the grip extension that are supposed to fit into the camera and there's only one receiving hole on my a9 for one of the pins. The other pin which has no hole to fit into seems to prevent a flush fit and I notice a small gap between the grip extension and the camera. Anyone else notice this? Unless I tighten it really tight it can slip a little.

A: this is design for Sony A9 and there is no issue using it