The 16.4' Sennheiser GZL RG 58 RF Antenna Cable is a coaxial cable optimized for shorter cable runs when connecting your wireless system's antennas, RF distribution, and other devices. The 50-ohm cable is equipped with a BNC male connector on one end and a BNC male connector on the other end.

For Wireless-Audio Applications    Optimized for Shorter Cable Runs    Impedance: 50 Ohms    Male BNC Connectors

• Impedance: 50 ohms
• Maximum attenuation: 34.8 dB/100m at 400 MHz, 56.4 dB/100m at 800 MHz
• Max operating frequency: 1000 MHz
• Diameter: 6.15mm

Related Questions and Answers

Q: 1. can I extend the cable if the antenna

A: This antenna uses an SMA cable, so it would be possible to purchase a longer one than that which is provided.

Q: 2. I've read that this strap can only handle upto 2.5lbs (1133grams). Is there a similar strap like this that can handle something heavier? (Sony a7rii (625g) - Sony GMaster 24-70 lens (886g) - Godox tt685s (410g) Flash plus battery flash = approx 4.3lbs or 1921grams)

A: The lugs on that camera do make it tuff to put a strap that can support more on it.You can use this, Ruggard Split D-Ring Twin Pack (12mm) B&H # RUSDR12MM MFR # SDR-12MM and then use a strap that can hold more like this Ruggard Lux Strap Plus with 3/8 Connector B&H # RULSP38 MFR # LSP-38.

Q: 3. What port does the cable for this unit go into the hollyland mars t1000 coms system?

A: the following unit plugs does not plug into a port but extends your wireless transmission frequency range when using the SYSCOM 1000T or Mars T1000 intercom transmission systems with this Extension Panel Antenna from Hollyland.

Q: 4. Is this strap padded and comfortable? Also, will it hold a Sony a7rii (625g) using a heavy Sony Gmaster 24-70 lens (886g) and Godox tt685s (410g) Flash plus battery?

A: The Mini QD Connectors on that strap can support no more than 5 lbs. We do not have that flash but you are coming very close to the limit in my opinion.I suggest adding this to the Sony camera, Ruggard Split D-Ring Twin Pack (12mm) B&H # RUSDR12MM MFR # SDR-12MM. With those you can then use a stronger camera strap.This is a strap with those rings that is stronger, Ruggard Lux Strap Plus with 3/8 Connector B&H # RULSP38 MFR # LSP-38

Q: 5. Is it possible to un-thread the webbing and remove the mini quick-disconnect connectors, or are they permanently attached?

A: The OP/TECH USA Mirrorless Strap with Mini QD Connectors (Black) comes with a built-in connector. Unfortunately, you cannot remove it from the neoprene strap.

Q: 6. Since the Syscom T1000 is a full 8 pack system, does that mean I have to buy 2 of the Extension panels to support all 4? Cause it says the extension panel only support 4 belt packs. Also, could I use the extension panel and still use the antennas that come with the Syscom t1000 together?

A: Yes, two of the Hollyland Extension Panel Antenna for SYSCOM 1000T/Mars T1000 would be required for full coverage of all components in the Hollyland Syscom 1000T-8B Full-Duplex Intercom System with Eight Beltpacks and Headsets. The Extension panel would replace the standard antennae used in the system and would connect to the same antenna input connections on the base station's back panel using the provided Communication Cable.

Q: 7. Are both of the ports meant to connect to the receiver or is one port a "thru" which can be connected to another antenna for increased signal?

A: There are two RP-SMA male mounts on the bottom to add optional antenna extensions for an even more stable transmission

Q: 8. Will this fit on a Shimoda Action X50 pack strap?

A: Yes, the OP/TECH USA Reporter/Backpack System Connectors (Set of 2, Black) can be connected to the 1" thick straps on the Shimoda Designs Action X50 Backpack.

Q: 9. What is the signal distance range on this antenna?

A: This unit extends the range of the original antenna by 100 meters.

Q: 10. Do I need to connect both SMA connections to the base station? This has been asked before but not clearly answered.

A: Yes, when you connect the Extension Panel Antenna to the base station, the user needs to connect all the antenna ports on the base station to the Extension Panel`s SMA port.