Easily hang your monitor in your cubicle without drilling into the desk or wall using the Mount-It! MI-785 Cubicle Wall Monitor Mount. An adjustable clamp allows the mount to hang from cubicle walls from 1.45 to 3.5" in thickness. It is compatible with monitors 32" or smaller, weighing less than 17.6 lb, with 75 x 75 or 100 x 100mm VESA mount compliance. To adjust height, simply pull the lever above the VESA bracket to slide the monitor up or down. Ten preset height adjustment increment slots provide 9.25" of overall vertical movement.

Recommended for Displays 32" or Smaller    Weight Capacity of 17.6 lb    Attaches to Cubicles 1.45 to 3.5" Thick    9.25" Height Adjustment Range

Related Questions and Answers

Q: 1. Does the tilt adjustment need to be fully tightened down to support a 7" monitor? If the tilt adjustment is left slightly loose, can the monitor be tilted with one hand while still remaining well supported (without falling forward)?

A: While the Atomos AtomX 5 and 7" Monitor Mount can support a 7" monitor it may not be wise to leave the tilt lose while operating, as it may not hold in position when the camera is bumped or moved.

Q: 2. is there any latency? If, is it better than Lilliput 10.1" A11?

A: unfortunately the latency time is not provided by the manufacturer

Q: 3. Does this monitor offer LUT (look up table) support?

A: Please buy model BM150-4KS-VBP or BM150-4KS-ABBP with LUTS function.

Q: 4. Any image latency? Does 4K introduce any picture delay? I'm looking for a good jib monitor that can handle both HD and UHD. Thanks

A: If properly set up between the camera and the monitor, there is no latency that has been reported. While this is a fine monitor for on set up and for looking at what the jib is doing, it might bee too big to be on the jib itself. For that you may wish to use a 7 such as a SmallHD 702 7 OLED On-Camera Monitor B&H # SMMON702OLED.

Q: 5. Can I order this monitor with a Gold Mount instead of a V mount?

A: sure,please place your order and contact LILLIPUT USA for sending a free Gold mount, the listing default with V-mount.thanks

Q: 6. Any ideas on how to mount this on a c-stand?

A: The BM150-4K comes with 75mm and 100mm VESA mount holes on the back, the standard version with installed a V mount or a anton Bauer mount plate, for installing a C-stand the V-mount or Anton Bauer mount has to be removed LILLIPUT ELECTRONICS(USA) INC

Q: 7. Will this fit nicely with a Small HD 702 touch?

A: Yes, the AtomX Monitor Mount is compatible with the SmallHD 702 Touch.

Q: 8. Is it possible to adjust the tilt pozition by hand when you switch from low to high angle shooting?

A: You would need to use the included hex wrench for such an adjustment.

Q: 9. Hi, it comes with a complete hard case? I only see pictures with the case body, but never seen showing a top or bottom cover.

A: Yes, The following unit comes with a flight pak style hard carry case.

Q: 10. I'm assuming yes but, will this work with the Shogun 7?

A: Yes, unit will mount to both Atomos AtomX 5 and 7