This Whirlwind Medusa Standard Series 20 Channel (0x Return) Snake is a snake cable with a heavy-duty steel stagebox at one end and a fanout at the other end. The cabling consists of heavy-duty, flexible Belden CM rated multipair cable. Each pair contains two twisted 24GA 7x32 polyethylene insulated conductors with 100% foil shield and 24GA drain wire.

The fanouts feature genuine Whirlwind connectors. Mic channels are numbered and return connectors are lettered by engraving the metal barrel with large, easy to read graphics.

Snake cables make it possible to combine several balanced (microphone) cables into one smaller diameter multipair cable, making setup and teardown much faster and easier, with less tangling and clutter than would otherwise be the case.

Heavy-duty powder coated steel stagebox with Whirlwind connectors.

Fanouts with multiple layers of rugged heat shrink at the most critical points.

Fanouts feature Whirlwind connectors with engraved numbers and letters.

Genuine Kellems wire mesh hanger to support the fanout at the board.

Genuine Kellems strain relief and grip with internal cable clamp.

Made in the U.S.A.

Related Questions and Answers

Q: 1. Does this remote work with the X-T2 and where would it attach?

A: Yes, this remote is compatible with the X-T2. It attaches to the "Remote" port on the side panel of the camera.

Q: 2. Will this work with a Fuji X-H2?

A: Yes, the FUJIFILM RR-100 Remote Release is compatible with the Fuji X-H2.

Q: 3. It is compatible with the vanguard alta pro 263ab

A: Yes, this head is compatible with the Vanguard Alta Pro 263AB.

Q: 4. Would you measure the outer rim specs for BH #IN173063 • MFR #173063 reflector? How wide is it?

A: According to the manufacturer, the front diameter measurement of the Intellytech Reflector for X-100 Fresnel measures 7 inches (177.8 mm) in diameter.

Q: 5. Does this ballhead works on an vanguard alta pro 263ab 100 tripod and is this ballhead arca swiss?

A: According to Vanguard, the Vanguard BBH-100 Ballhead uses the Vangaurd QS-60 plate which they say is an "Arca-Type Compatible Dovetail Plate."

Q: 6. Does it work with Fuji XT-50 if I use a 2.5mm to 3.5mm converter with it?

A: Yes, using a Stereo 2.5mm Female to 3.5mm Male Adapter will allow the FUJIFILM RR-100 Remote Release to work with the XT-50.

Q: 7. Will this work with an ALTA Pro 2 tripod?

A: Yes, the Vanguard BBH-100 Ballhead would be compatible for use on the Vanguard Alta Pro 2+ 263AT Aluminum Tripod.

Q: 8. Can you add a delay to any of the outputs to sync audio to video camera?

A: No, you would not be able to accomplish this with the L-20R.

Q: 9. Does this work with the GFX 100S, 100 II and 100S II cameras?

A: The FUJIFILM RR-100 Remote Release is compatible with the FUJIFILM GFX 100S, GFX 100II, and GFX 100S II Medium-Format Mirrorless Cameras.

Q: 10. My camera is a FILM CAMERA TX-2, it is not DIGITAL CAMERA XT-2. Does RR-100 suit my camera?

A: The old TX-2 takes a mechanical cable release that screws in the side. Click the link below to view; https://www.bhphotovideo.com/c/buy/threaded-cable-releases/ci/27981/N/3777857687