The PHANTOM II Pro from Art is a 2-channel portable phantom power supply with XLR connectors that operates off of two 9 Volt batteries. Condenser microphones with voltage requirements from 9-48 Volts are supported.

XLR Input and Output Connectors

Lightweight, 2-channel portable phantom power supply

9-48V condenser microphone requirements supported

Related Questions and Answers

Q: 1. Can I upscale the HDMI output of the BMPPC 6K G2 from 1080p60 to 4K using this HDMI to SDI 12G converter?

A: The Blackmagic Design Micro Converter HDMI to SDI 12G with Power Supply does not offer upscaling. We will list a 4k scaler option below. DECIMATOR 12G-CROSS 4K HDMI/SDI Cross Converter with Scaling and Frame Rate Conversion BH #DE12GCROSS

Q: 2. Can this be used as a graphics overlay insertion tool for key and fill?

A: The Blackmagic Design Micro Converter HDMI to SDI 3G cannot be used as a graphics overlay insertion tool for key and fill.

Q: 3. Does this support 1080p60?

A: Yes, Blackmagic Design Micro Converter BiDirectional SDI/HDMI 3G supports 1080p60.

Q: 4. Would the BiDirectional facilitate record start/stop triggering of my MixPre 6ii by my UMP G1 (that is start/stop recording on the UMP causes start/stop recording on the MixPre)?

A: No it will not.

Q: 5. Can i use both outputs (SDI & HDMI) at the same time with 1 input?

A: Yes, the Blackmagic Design Micro Converter BiDirectional SDI/HDMI 12G with Power Supply is capable of sending an SDI and HDMI signal at the same time with one input.

Q: 6. Can I send one HDMI signal to two different monitors via SDI without needing an additional SDI distributor?

A: The Blackmagic Design Micro Converter HDMI to SDI 3G can convert a single HDMI source into two SDI video feeds which are rounded out through the SDI outputs. SO yes, you can send the SDI signal to two monitors at the same time.

Q: 7. compatible with rs3 pro?

A: Yes, the Tilta Dual-Handle Power Supply Bracket for Select DJI Gimbals is compatible with the DJI RS3 Pro Gimbal.

Q: 8. Will this work with the Ninja V using Hollyland Cosmo C1 to Sumo 19 SE Monitor?

A: It would be possible to use the Blackmagic Design Micro Converter HDMI to SDI 3G (with Power Supply) to take an HDMI signal from a Atomos Ninja V to input into the Hollyland Cosmo C1 However, the Hollyland Cosmo C1 can cross convert HDMI signals from the transmitter to output via SDI on the receiver.

Q: 9. Does this device work to boost the signal of the SDI signal?

A: The Blackmagic Design Micro Converter Bidirectional SDI/HDMI 3G does not boost the signal of the SDI.

Q: 10. What will happen if I input a 12G SDI signal from the camera to this? Will it be downscale to standard format? Will the 12G signal recognize?

A: No, you will just be using a 12g sdi cable to get a 3g signal. The unit will not upscale.