The Kalt Small Changing Bag features a lightweight black nylon outer bag, with an interior bag constructed of rubberized nylon/cotton blend, and rubber wrist bands for comfort. This affords both light weight, and great opacity.

Its double lined, double zipper system guarantees it to be light-tight.

A changing bag is used to load and unload light sensitive material when a darkroom is unavailable.

Related Questions and Answers

Q: 1. Im seeing the most complaints being about the plastic lining. Would it be worth it to simply have the lining replaced on the strap?

A: It would be best if it were fabric on both sides of the strap but for the price I did not expect much

Q: 2. How long are the silver legs? What is the diameter of the shaft? Can the top, where the tighten bolt (under ball) be removed?

A: The silver legs are approximately 3 and 3/4 inches when they are in position on the desk the diameter of the Shaft is approximately just around 7/8 of an inch the whole top section is removable as one piece from the shaft.

Q: 3. which RRS bag to fit RRS BH30 and TFC 14?

A: The Really Right Stuff Small Tripod Bag (Black) B&H # RETQB64SMLLB can hold a TFC-14 tripod outfitted with a BH-30 Ball head, which is about 20.3 inches.

Q: 4. Can I fit Ronin S and monopod?

A: The following unit will accommodate a light stands up to 35 inches. Case will fit your monopod and Ronin s system. I would just tear down equipment when traveling.

Q: 5. Do these bags have the new logo or the old one as displayed in the picture?

A: The large has the new logo,

Q: 6. can this be used to load 4x5 film?

A: Yes but as always when it comes to changing bags. The film might be prone to dust issues if you are loading film into film holders.

Q: 7. Will this hold the Manfrotto MT290XTA3 with the RRS BH-25 ball head? I don't mind a very snug fit with no room to spare.

A: No, the Really Right Stuff TQB-64 SMALL BAG is about an inch too small. The next size up will work, https://bhpho.to/3BBMhHY .

Q: 8. Can I use this for a 3-reel tank? Is it big enough?

A: Yes.

Q: 9. Can you tell me how long the silver legs are? Can the ballhead, along with the tighten screw housing be removed ? How long is the shaft, from the legs to the tighten screw? What is the diameter of the shaft?

A: When extended, the silver legs are slightly over 3 3/4 from the body each. The bullhead itself cannot be removed, but the top part of the housing unscrews from the tube, as well as the bottom part of the housing that is the leg support. The shaft itself is 1 diameter; the top housing is 1 1/8 ; the bottom housing is 1 1/4 . With the legs extended, the length from the tabletop to the top of the tightening nut that tightens against the camera body is 7 5/8 .

Q: 10. Is the inside of the bag dust free?

A: The amount of dust depends on how the bag is stored.