Whether for commercial or personal use, the black 24 x 18" Three-Shelf Utility Cart will come in handy time and time again. Rolling smoothly and quietly on four 4" casters, two of which have locking brakes, the cart's three molded polyethylene shelf tubs can support a total of 300 lb. of cargo. Each tub shelf measures 24 x 18" and is 2.75" deep.

Sturdy Polyethylene Construction    Total Capacity 300 lb    Won't Stain, Scratch, Dent, or Rust    Four 4" Casters, Two with Brakes    Three 2.75" Deep, 24 x 18" Shelf Tubs    Shelf Tub Clearance: 12"    Molded Handle    Limited Lifetime Warranty

Polyethylene cart with 3 tub shelves

Four 4.0" casters, two with locking brakes

Top shelf is reinforced with a steel bar

Clearance is 12" between each shelf

2.75" deep tubs

Sturdy polyethylene won't stain, scratch, dent or rust

Push handle molded into top shelf

Easy assembly with included rubber mallet

Related Questions and Answers

Q: 1. Can these be used with Manfrotto autopole system?

A: yes!

Q: 2. what diameter rod are the slots designed for? Not a word on site?

A: The slots on the 045-6 are about 1 inch wide. However, they are only designed to fit the slotted tabs on a Manfrotto Expan Drive.

Q: 3. what about canvas backdrops? Will these hold three?

A: By mounting these Manfrotto 045 Background Triple Hooks for Three Backgrounds (Box of 2) to a wall stud, it will make them very secure and will easily hold 3 backdrops. However, do note you will need either the Manfrotto Expan Drive Set or the Impact Varidrive, along with a crossbar such as the Manfrotto 047-3 Alu-Core for Uncored Paper or Cloth - 12' (3.6 m), B&H # MA0473, or the Impact Cross Pole for Uncored Paper or Fabric Backgrounds (106.3"), B&H # IMVPC5, to support a canvas backdrop with the above background hooks.

Q: 4. How much weight it can support?

A: 6 paper rolls with chains no problem.

Q: 5. How long is the bracket? Thanks!

A: Length is 732.5 mm (28.8 )

Q: 6. can I install this directly on a crossbar? (the images shows installed vertically, but I want to place the clamp on a crossbar)

A: No, the Manfrotto 044 Background Holder Hooks and Super Clamps for 3 Backgrounds is designed to work on autopoles not a cross bar.

Q: 7. cCould these be mounted to the ceiling in a low ceiling studio situation?

A: That's exactly how I mounted them in my studio. Just take into consideration how low they might sit in yours. I was fortunate enough to not have a problem with the lowest roller, I never saw them in my shots. By also think about what your mounting them into, like material. My ceiling was just drywall and the studs didn't line up to where I wanted the rolls so I used some 1 wood planks to help reinforce. Good luck with your studio build. These were a welcomed addition to my studio.

Q: 8. Does it come with the Manfrotto R044,01 mounting kit?

A: Yes, the Manfrotto R044,01 Mounting Kit for 044 and 045 Background Hooks is included with the Manfrotto 044 Background Holder Hooks and Super Clamps for 3 Backgrounds - Set of 2. The R044,01 Mounting Kit can also be purchased as a separate part via a special order.

Q: 9. Are the background holders removable from the super clamps?

A: Yes. The Manfrotto 044 Background Holder Hooks and Super Clamps come detached as 2 Cast Hooks and 2 Super Clamps.

Q: 10. A few Questions: 1.) Do I have to buy the poles separate? 2.) Do I have to buy the expan drive set seperate and is that the thing that allows me to raisw and lower the paper? 3.) Do you sell a kit with everything you need?

A: You can buy it as a kit ready to go https://bhpho.to/2yNURCQ. This is a easy kit for raising and lowering up to three backgrounds.