The black SKB 3I-1610-5B-E Mil-Std Waterproof Case 5" Deep without Foam is an injection-molded ultra-high-strength polypropylene copolymer resin case. It features a gasketed, dust and waterproof, submersible design that is resistant to corrosion and impact damage. The case is ATA category-1 rated. There is a continuous molded-in hinge, "trigger release" latch system, comfortable, snap-down rubber overmolded cushion grip handle and automatic ambient pressure equalization valve. It is resistant to UV, solvents, corrosion, fungus, and impact damage, and the cases are lockable with a customer-supplied padlock.

Polypropylene Copolymer Resin Case    Gasketed, Dust & Waterproof    ATA Category-1 Rated    Continuous Molded-In Hinge    Trigger Release Latch System    Automatic Ambient Pressure Valve    Rubber Cushion Grip Handle

Injection-molded ultra-high-strength polypropylene copolymer resin case

• ATA (Air Transport Association) category-1 rated
• MIL-STD-810F Military specification for resistance to UV, solvents, corrosion, fungus, and impact damage
• MIL-STD-C-4150J Military specification for waterproof and water-vapor proof cases for transit and storage
• IP67 Military specification for protection against dust and against the effect of immersion between 15cm and 1m
• MIL-STD-648C Military specification for automatic ambient pressure equalization valve

Trigger release latch system is lockable with a customer supplied padlock

Continuous molded-in hinge for added protection

Temperature rating = -40 to +160°F (-40 to +71.11°C)

Snap-down rubber overmolded cushion grip handle

Related Questions and Answers

Q: 1. Greetings,which are frequency rates of the device and (or) microphones? My university is looking for 20 - 44.000 Hz because of speech - songs, even special songs - for example the Overtone singng ( http://en.wikipedia.org/wiki/Overtone ).

A: This product is calibrated to record from 20Hz-20kHz.

Q: 2. Phantom

A: The Zoom H6 Portable Handy Recorder can supply 12, 24, or 48V of phantom power to the XLR jacks.

Q: 3. Can this be used for a Nanuk 950?

A: This Pelican divider will be too large.

Q: 4. Is the 1/8 line out a balanced TRS connection?

A: Yes it is TRS, No it is not balanced. Its a stereo line output.

Q: 5. Does this fit into the Pelican 1615AirTP Wheeled Check-In Case?

A: Sorry, no that kit is the wrong size. You need to use this one: TrekPak Divider Kit for Pelican 1615 Air Case B&H # TRPA1615CI.

Q: 6. Can you solo all four mic pres during recording and playback?

A: Yes you can solo both during recording and playback very easily by pressing on/off the buttons for each channel. It's one of the best features of the H6

Q: 7. Does this come with a carrying case that fits all the components?

A: A hard case is included.

Q: 8. Cmo adapto o ensamblo la grabadora en una cmara Cannon Mark IV?

A: To connect your H6 to a Canon Mark IV, simply connect an aux cable from the Line Out of your H6 to the Mic In on your Mark IV. Then, enable the attenuator in the Mark IV's audio menu and set the gain to your liking.

Q: 9. Can I mount it on a boom pole?

A: with some rigging, yes. I use velcro.

Q: 10. will this one will fit in a 1620 ?

A: No.