The beige E6 and E6i Snap-On Microphone Cable from Countryman is designed for use with the E6 and E6i earset microphones. It can be used to replace a cable in the event of a short or break and is an alternative to replacing the entire microphone.

It features a snap-on design that has a Screw-on Mini 4-pin connector for use with Sabine wireless bodypack transmitters.

1mm Diameter Cable    Screw-on Mini 4-pin    Beige

These replaceable cables are available in various connector types to accommodate various wireless microphone transmitters. This cable features a Screw-on Mini 4-pin connector for use with Sabine wireless bodypack transmitters.

The replacement cables are available in matching E6 and E6i ear set colors. This cable is beige.

Related Questions and Answers

Q: 1. Does it works for Canon 5D mark3? Does it has decoding chip inside?

A: There is no decoding chip in this battery adapter. However, we must admit not knowing of any such chip in any such adapter. So that we may be of further assistance with your question, please email us at provideo (at) bhphoto dot com.

Q: 2. Will this work EOS R5C 8K 60P RAW?

A: This will work on the R5C regardless of the frame rate.

Q: 3. Compatible with Canon EOS R?

A: Hi, yes, this is compatible with the EOS R.

Q: 4. Does this work with the new Canon EOS R?

A: Yes, the Canon DC Coupler DR-E6, does work with the New Canon EOS R.

Q: 5. Hi - just rec'd a crane 2 for use with a canon 70D - can this coupler use/plug in to the power from the Crane 2 batteries to power the camera?

A: Yes. you'll need the DR-E6 , B&H # CADRE6 . see illustration in Zhiyun manual below, page 22. https://static.bhphotovideo.com/lit_files/371635.pdf

Q: 6. Hello, I have a micro-battery LP-E6 that I bought for use with my BMCC4k, when I put it in my canon battery charger LC-E6, the light flashes without stopping and it seems that it does not charge the battery at all, do you know that it may be happening?

A: consider this charger , Watson Compact AC/DC Charger for LP-E6 & LP-E6N Battery B&H # WACCNLPE6

Q: 7. For the 5D Mark III, I found the battery door needs to close for the camera to turn on. How have you used the coupler with the battery door since there is no space for the coupler wire to close the door? Or have you taken off the door, in which case, how did you depress the trigger so that it would recognize the power source and turn on.

A: There is a tiny rubber slot in the front of the camera (on the grip, where the end of your pinky finger sits) that opens up, allowing the dummy battery cable to run out.

Q: 8. What size is the barrel connector, 2.1 x 5.5mm?

A: Yes, the barrel connector of the LanParte E6 Battery Dummy Pack (B&H# LAE6P01) has a 2.1mm center pin and can accommodate a barrel connector that has an outer diameter of 5.5mm.

Q: 9. Hello! Does this fit the Zacuto EVF Pro? (ZAZFINDEEVFP)

A: Yes. Also bought one for the camera body and hooked it up to Anton Bauer battery mount. Works great.

Q: 10. Would this work to power the Blackmagic pcc4K? It uses the same E6 batteries that my 5D does. I want to plug in the Blackmagic to the DC output on my Zhiyun Crane 2. Thanks

A: It will not. While this does have the proper LP-E6 style dummy battery for the Pocket Cinema Camera 4K it is not compatible with the Crane 2.