This RCA Female to 3-Pin XLR Female Adapter from Remote Audio converts a male 3-pin XLR to an RCA female. Useful for connecting a variety of mono audio equipment, this adapter provides you with flexibility when working with analog audio equipment.

For Mono Audio Signals    Strong Single-Piece Adapter

Related Questions and Answers

Q: 1. Can I use this with the PocketWizard Plus II?

A: Yes. Note: The CM-N3-P is an older cable that has been replaced by the CM-N3-ACC combined with the PTMM to allow you to pre trigger your camera. The CM-N3-ACC is for Canon cameras with the N3 connection. The PTMM can connect to any -ACC PocketWizard cable to give a pre trigger function.

Q: 2. Will this work with a pocket wizard?

A: Technically, this cable could work with a Pocket Wizard if you had a cable with a 3 pin remote connection for Canon which terminates into a miniphone connector.

Q: 3. Does it works with Nikon D610?

A: No it does not work with the D610. The latest camera it works with is the D800.

Q: 4. Does the Nikon WR-A10 Adapter sync with Meike Mk-GT620?

A: We do not sell the Meike product. We therefore can only say that we were unable to find any report that successfully with any Nikon product.

Q: 5. will it work on a D700, D300 and D2H? I have all three and they have 10 port connector but; the D700 has both 10pin and small usb.

A: It works with all of those cameras says Nikon USA website.

Q: 6. will this cable (Canon RA-E3) work with my R3?

A: The Canon RA-E3 is not for the EOS R3 camera. The Canon EOS R3 already has the E3-type socket, so you don't need this adapter for the camera.

Q: 7. Will the Canon RA-E3 work with my R3 & R6?

A: The Canon RA-E3 will work with the EOS R6, but does not need to be used on the EOS R3 because it already has the E3 socket for shutter release remotes.

Q: 8. Does this support high speed sync with sb 5000?

A: Yes.

Q: 9. Can I use this with the Nikon 7100

A: No, this remote receiver is not compatible with the Nikon D7100. The D7100 does not have the required 10-pin connection to connect the system to. Below is a link to a similar type of remote control which will plug into the D7100s remote control port and will wirelessly trigger the flash via radio transmission. Seeh the link below for details:http://bhpho.to/1dmOq7d

Q: 10. Do I need this adapter to use the Canon shutter release remote with my Canon 5D Mark IV?

A: No you don't, the 5D mk IV has a N3 type socket. Depending on your shutter release remote. If it's an N3 type, it will just plug into the 5D, but if it's an E3 type(like a headphone jack) then you will need another adapter, not this one.