The Tram Vampire Cable Holder TR-GCH (Gray) is a cable holder with vampire pins designed specifically for use with TR50 lavalier microphones. Use this practical unit to perfectly position your microphone for optimum recording results.

Use this convenient clip to enhance your audio recording results by achieving perfect microphone placement every time.

Related Questions and Answers

Q: 1. Can this handle the weight of a 9’ x 20’ vinyl roll?

A: The cross bar can handle it if the roll is cored.

Q: 2. Is it possible to connect 2 of this to get double the length? of course with 3 stands....thanks

A: i have used a screw on adapter on the end of the middle light stand to attach two.

Q: 3. does it fits for the 6k pro cage too, right?

A: Yes , the Tilta Wise Drive Holder attaches directly to Tiltaing Half and Full Camera Cages via a 1/4″-20 screw and locating pin. Tilta Wise SSD Holder for BMPCC 4K Cages (Tactical Gray) BH #TITASSDHWS

Q: 4. Aside from the price and colour, what are the differences between the Manfrotto 272B Adjustable Background Holder (108 ) and the Manfrotto 2983 Adjustable Background Holder Crossbar (108 )?

A: I only have the 272B Holder. If you want to use a short roll of paper seamless (or long roll, too) you have to remove one of the ends with an allen wrench. The rolls do not fit over the stand connectors.

Q: 5. Do I have to buy the Profoto OCF II Gel Ring in addition to the Holder or does the Gel Ring come with it?

A: The Profoto ocf ll Grid and Gell Holder is availble as a kit BH# pr10126 for $99.00.

Q: 6. Based on answers, I see that you have to remove the end pieces with an Allen wrench to insert a roll of seamless or muslin background, I can only loosen one of the Allen screws and can't get the end pieces off, is this normal?

A: The screw can be removed with your fingers. No tools necessary.

Q: 7. Is there any way to fix more than one of these to a single C-stand? Ie two crossbars, 3 stands, 2 rolls of seamless set at 90degrees?

A: In my estimation there should be, yes, perhaps you may need an extension to the pins on the stand, but the crossbar has decent sized openings and can be adjusted in width to meet your needs. Hope this helps.

Q: 8. How much weight does this pole hold? I am looking to attach a super clamp and a 5D Mark II.

A: It can hold a fair-bit of weight, but because it's designed to hold seamless paper or a cloth backdrop there's quite a bit of deflexion in the pole i.e. it's not very steady. In a pinch, it's probably fine. There are better ways to hold a camera overhead. Personally, I'd use speedrail. I've done 12' spans with speed rail. Avenger and Matthews both make clamps to attach speedrail to stands and then a super clamp works fine to attach a camera and/or lights.

Q: 9. What is a Type-25 attachment? I have three light stands with 3/8" screws at the top end (i.e. not the usual 5/8" spigots). Will this work with them?

A: This cross bar fits on a 5/8" stud on a standard light stand.

Q: 10. is there an adapter for using this crossbar to mount on a pair of ultimate speaker stands?

A: The crossbar accepts 9.5mm spigots, the speaker stand uses 35mm spigots, you probably better off getting proper lights stands