The tan E6 Omnidirectional Earset Mic, Highest Gain, with Detachable 1mm Cable and Mini 4-Pin Connector for Sabine Wireless Transmitters from Countryman is a vocal microphone with an adjustable boom that weighs less than one-tenth ounce. It is a water- and wind-resistant microphone that can be used on either ear for capturing audio in houses of worship, theater, or outdoor vocal and speech applications.

The low-profile, omnidirectional E6 Earset virtually disappears against the skin, so performers forget they're wearing a mic. Three sensitivity options cover general speaking to extremely powerful vocals and four color options allow you to match the E6 to your skin tone for minimum visibility.

In addition, the E6 Earset features three omni caps (very bright +8 dB, bright +4 dB, and flat +0 dB) that deliver response characteristics for most other applications such as recording flute and violin. The E6 Earset is available as a directional microphone too with cardioid and hypercardioid caps. This omnidirectional E6 Earset's cable terminates to a screw-on mini 4-pin connector for direct connection to a Sabine SW16T or SW30T wireless bodypack transmitter.

For Vocals and General Speaking    Detachable 1mm Cable    Mini 4-Pin (SB), See Description    20 Hz to 20 kHz Frequency Response    Headroom for Strong Vocals    Includes +8, +4, and +0 dB EQ Caps    Windscreen    Cable Clips    Carrying Case

The Countryman E6 head-worn Earset is small and lightweight, and is hardly visible from a distance.

The E6 Earset's stainless steel boom is built tough and can be bent and re-bent many times to fit different performers. The E6 is highly resistant to makeup, sweat, and moisture when used with the supplied protective caps.

The flexible boom is easily shaped right on the performer's face and is available in multiple skin tones. Their protective caps let you shape the frequency response for different situations or to match other microphones; caps for the directional earset adjust the pattern from cardioid to hypercardioid. Choose a sensitivity for speaking or singing with up to 140 dB SPL capability.

The E6 provides high-quality audio with low distortion and an SPL of up to 140 dB. It delivers rich, full band audio quality.

Easy adjustment keeps the mic in a position for rejecting unwanted sounds. Countryman's omnidirectional Earset offers a reduction of 12 dB compared to a lavalier mic, while the directional E6 Earset provides even more isolation. Excellent for houses of worship, theater, and outdoor events.

An E6 replacement cable installs in seconds. The snap-on cables are rugged and available for almost any wireless transmitter or for XLR inputs with phantom power.

For general speaking.

Related Questions and Answers

Q: 1. Will this Vello RS-C1 II work with Canon M5?

A: Yes it will, the cable is not very long but I stand next to my gear when set up anyway. I have a few so there is always one regardless what camera bag I am strutting with.

Q: 2. Can this power a device which draws: 5.5W, 0.46A at 12V?

A: This device is specifically for powering the Redrock Micro microRemote System with a Canon LP-E6 style battery. It will have the proper draw for that system only and may not work with others.

Q: 3. Will the Vello RS-C1II Wired Remote Switch work with the following cameras? 1) Canon Powershot G5 X camera?2) Pentax K-1 camera?

A: Yes, the Vello RS-C1II Wired Remote Switch for Select Cameras with 2.5mm Sub-Mini Connections would be compatible for use with both the Canon Powershot G5 X Digital Camera and the Pentax K-1 DSLR camera. Both cameras use the 2.5mm sub-miniphone remote terminal connector.

Q: 4. I just purchased two (2) ANDYCINE 35-LED Mini On-Camera Lights (Nikon EN-EL15). But neither of them have 4-step dimming as listed in the description. Did I get defected ones? I had them plugged into a wall outlet in case that makes a difference since I don't have Nikon EN-EL15 batteries.

A: Four step should be inherent to the light fixture regardless of the type of power device being used for powering the unit. There may be a product defect if these four step options are not accessible.

Q: 5. Can the transmitter send video signal to the receiver remotely and send video signal through its Out port at the same time?

A: The Shimbol TP Mini 600' HDMI Wireless Video Transmission System can transmit up to 600' with line of sight. It will not work beyond that to a remote location separate from where the transmitter is located. The receiver has two HDMI outputs, while the transmitter has one HDMI input and one output.

Q: 6. Is this wired remote compatible with the Canon 5D Mark II?

A: No, it is not.Remote switch should be equipped with an N3-type terminal to connect the camera (5D2).You may need below item instead:https://a href= http://www.bhphotovideo.com/c/product/765666-REG/Vello_RS_C2II_RS_C2II_Wired_Remote_Switch.html target= _blank www.bhphotovideo.com/c/product/765666-REG/Vello_RS_C2II_RS_C2II_Wired_Remote_Switch.html/ahttps://a href= http://www.bhphotovideo.com/c/product/164276-REG/Canon_2476A001_Remote_Switch_RS_80N3.html target= _blank www.bhphotovideo.com/c/product/164276-REG/Canon_2476A001_Remote_Switch_RS_80N3.html/a

Q: 7. how long is the cord between the camera and the remote?

A: It is approximately two feet long.

Q: 8. is it compatible with BM micro cinema camera?

A: Yes, You can utilize the the Canon LP-E6 Power Kit for your setup.

Q: 9. Is this compatible with the canon 7d?

A: For the Canon 7D, you would need the Vello RS-C2II Wired Remote Switch for Select Canon 3-Pin Cameras.

Q: 10. Can two or three sets be used simultaneous for multi camera setups?

A: Shimbol does not state if multiple sets of the Shimbol TP Mini 600' HDMI Wireless Video Transmission System can be used in the same area. You may be able to use multiple sets, but there will be the possibility of interference when doing so.