The Tiffen 3 x 3" Center Spot Filter is a softening filter that allows you to maintain sharp, clear focus in the center of the image while blurring the perimeter of the frame. This helps to isolate your central subject matter while softening the surrounding areas.

Tiffen filters are made using ColorCore technology, a process that involves laminating the filter substrate between 2 pieces of optical glass and grinding flat to a tolerance of 1/10,000th of an inch. This filter measures 3 x 3" / 76.2 x 76.2mm.

Maintain Central Focus and Soften Edges    Isolate Subject Matter    ColorCore Technology

Clear central area of the filter keeps subjects in the middle of the frame in focus while softening surrounding areas.

Helps to isolate subject matter and lessen distracting backgrounds.

Related Questions and Answers

Q: 1. Godox VSA-36° Spot Lens WORK WITH SL200 BI . ??

A: The Godox VSA-36° Spot Lens BH #GOVSA36K can be used with an SL 200.

Q: 2. How cold can the Godox VSA be and not be damaged?

A: The Godox VSA-36° Spot Lens does not have an IP rating.

Q: 3. Can I use this with a profoto pro head, with a profoto pro pack being mindful not to go over 600w/s and not use a modeling light? If your answer is no, can you point me to the direction of the product that will allow me to make gobo designs with pro pack and heads. Thank You,

A: You can use this spot on a flash with an output below 600ws.

Q: 4. Does this work equally well with the flat front Profoto B1 as it does with other bare bulb type strobes?

A: Yes this Optical Spot would work just was well on the Profoto B1 as it would with a bare bulb Profoto flash head.

Q: 5. Does it freely pan around, or is there some amount of friction (which cannot be changed) while panning?

A: When the tightening lever is loosened, the head moves freely.

Q: 6. Hi, can this head be used on Monopod, Manfrotto 290 Aluminum Monopod? Thanks.

A: Yes, that head can work on most Monopods. It has a 3/8 female thread. If the monopod does not have a 3/8 thread then you will need a bushing like this, Wimberley BS-100 3/8"-16 to 1/4"-20 Brass Reducer Bushing MFR #BS-100 • BH #WIBS100

Q: 7. Which country is this made in?

A: This ball head is manufactured in China.

Q: 8. since do not make Bowens any more will this work on Godox one too. or not?

A: Yes, the Westcott Optical Spot by Lindsay Adler for Bowens will accommodate all 3 pin Bowens system on the market.

Q: 9. Does this light fit with forza 500? I know it does with aputure 300x but it seems the nanlite bowens mount it's a bit different

A: It is not recommended to use the Godox VSA-36° Spot Lens on the Forza 500.

Q: 10. Is this can work with godox sk300??

A: Yes, that will work on the SK300 and SK300 II. It no more than 600 watts and has a Bowens S mount. Note, you should not use the modeling lamp on the strobe. It is 150 watts and is not made for the heat that produces.