The Stainless Steel Photography Light Stand from Neewer extends from a minimum height of 3.2' to a maximum height of 7.2', offering a load capacity of 22 lb. It folds down to 2.6' for easy storage and transportation. This stand features a reversible 1/4"-20 to 3/8" stud adapter for wide compatibility with equipment and accessories.

Load Capacity: 22 lb    Max Height: 7.2', Min Height: 3.2'    Folded Height: 2.6'    Stainless Steel Construction

Related Questions and Answers

Q: 1. Does this work well with Godox S Bracket?

A: I don't see why not. It has a standard mounting stud.

Q: 2. Would this be able to support the weight of a DSL with a 70-200mm attached?

A: The following unit supports 20lbs payload.

Q: 3. Is there an assembly manual? Mine came in quite a few pieces and wall. Some of them are obvious how to put together others are not.

A: No, but feel free to reach out to our live chat team for step by step assistance. https://www.bhphotovideo.com/find/livechat.jsp

Q: 4. Can a baby pin be used in place of camera mounting plate?

A: Yes you could use a double pin such as the Impact SRP-113 Long Double Stud 5/8" B&H # IMSRP113 in place of the camera mounting plate.

Q: 5. Will this hold an Einstein strobe and 64 PLM?

A: This stand is designed for a laptop or a camera.

Q: 6. what is its size when folded?

A: It is just a smidge over 34 inches.

Q: 7. So, I understand the minimum height is 3ft 9in, however, what is the lowest the sliding arm will go? Will it slide all the way down the pole until it rests on the black bottom?

A: Yes.

Q: 8. Is it possible to use this as a camera stand? If yes, what grip head or other accessory would I need to buy?

A: Yes, you can use Godox 240FS Wheeled Light Stand (7.9') for a camera and you will need to get a ball head of appropriate size, please check the weight of your camera with a lens used and then pick a ball head that has relevant load capacity. As a reference Benro GX35 Two Series Arca-Type Low Profile Aluminum Ball Head https://bhpho.to/3gTyWyn

Q: 9. Any recommendations for rubber feet attachment?

A: We can special order the feet. https://bhpho.to/32moAkB

Q: 10. I dont understand the 3ft 9 in min height, why can't it go lower than that, is there a way to get the minimum height lower if I don't need the 7.9' max height?

A: The design of that stand makes it have a minimum height of 3.9 feet. it cannot be changed to make it work lower. Note, the stand is over 7.9 feet always. The arm on that stand slides on the stand 3.9 feet to 7.9 feet.