The 3/8"-16 Bridgeplate Screw from Lanparte is a standard screw that attaches any camera with a 3/8" thread onto your bridgeplate.

Standard 3/8"-16 Screw

Related Questions and Answers

Q: 1. the the non twist pins arri standard spacing?

A: The Amaran Baby Pin Adapter to 3/8"-16 Screw does fit into Arri standard receiver.

Q: 2. Is this piece necessary to use a TILTA TT-0506-A19 19mm Universal Dovetail Shoulder Mount System with a BMPCC 6k cage?

A: this is a 19mm Studio ARRI Standard Bridgeplate and is required if you're using 19mm accesories

Q: 3. Is the start and stop record function compatible with the BMPCC 4K & 6K?

A: LanParte uses standard LANC control, therefore there is start and stop compatibility with the Blackmagic Design Pocket line.

Q: 4. How long is this camera screw in inches from the base to the end (not including the head)?

A: It is probably not long enough. I can't remember exactly how long, but I purchased this screw to use with a small teleprompter. It needed to go through the tripod camera plate then through the teleprompter plate into a small threaded universal mounting plate. It only went flush with the teleprompter plate; not enough threads to securely attach the teleprompter. It would be helpful if the description or specs gave the length so that we could make a more informed decision.

Q: 5. Can this be used with the Canon EOS-1D X Mark II? The Mark II is higher by 0.2in than the EOS 1DC. Thank you.

A: While we are not able to test the configuration you are asking about, it is our opinion that this rig will accommodate the 1D X Mark II.

Q: 6. Are the pins collapsable for mounting a ball head on the screw?

A: No, the pins on the amaran Baby Pin Adapter to 3/8"-16 Screw are not collapsible.

Q: 7. How is this shipped? Will I receive multiple boxes for each kit component or will it be one box with the case that contains the remaining kit components?

A: All the components will be nicely arranged in the pre-cut foam insert in one protection case! So you will only receive one box.

Q: 8. Will this work with an fs7?

A: You can mount an FS7 on this 15mm Base Plate.

Q: 9. What does "side-mounted" mean?

A: The Ultralight Side-Mounted ARRI Ball Adapter has its 3/8 screw mounted at a 90 degree angle. Please see the image below. Image - https://bit.ly/3V30feU

Q: 10. How much weight can this support?

A: I use mine to connect to a counterweight for balance on a camera rig -- around five pounds. The clamp seems fairly sturdy and could probably handle even more weight (within reason).