Record single person vlogs or TikToks with the VM10 Wireless Microphone System from LituFoto. The system includes one clip-on transmitter with built-in microphone, a lavalier microphone for low-profile recording, and a dual-channel receiver with both 3.5mm TRRS and USB-C connectivity. Attach your transmitters to your talent's lapel and mount your receiver to the cold shoe mount of your camera or your smartphone with the included mounting accessories. Both components can communicate from up to 492.1' away without obstruction via 2.4 GHz frequency or from 164' with obstruction.

Each component features a bright TFT display to monitor audio channels and settings. Onboard controls allow you to toggle mono and stereo recording, mute, the 150 Hz low-cut filter, or the 15 levels of gain. An internal DSP chip facilitates noise reduction to help alleviate environmental interference. Use the included furry windscreen to further improve sound clarity and monitor your audio in real time with the microphone output on the receiver. Built-in batteries keep the system running for 10 hours at a time. Recharge the components with the 2-in-1 USB-C charging cable in just 1.5 hours.

For Content Creation, Vlogging    1-Person Shoots with Camera or Phone    1 x Transmitter with Built-In Mic    Dual-Channel Receiver    491.1' Line-of-Sight Transmission    3.5mm TRRS and USB-C Ports    Low-Cut Filter, DSP Noise Reduction    Included Lavalier Microphone    15-Levels of Gain, TFT Displays    Built-In Rechargeable Batteries

• 2.4 GHz frequency, 492.1' line-of-sight transmission, 164' transmission with obstruction
• Dual-channel receiver with mono and stereo recording modes
• TF displays and onboard controls
• Mute, 15-levels of gain, 150 Hz low-cut filter, volume
• 3.5mm TRRS and USB-C audio output ports
• 3.5mm TRS headphone port
• 450mAh batteries with 10-hour battery life, 1.5 hour charging time
• 3.5mm TRRS cable, 3.5mm TRRS to TRS cable
• Lavalier microphone, USB-C 2-in-1 charging cable
• 1/4" to 3.5mm adapter jack
• Reset pin for restart/pairing
• Phone clamp with cold shoe mount and 1/4"-20 thread
• Cold shoe adapter
• Carrying case

Related Questions and Answers

Q: 1. With this device mounted on Nikon DF hotshoe, can I put the SB900 flash on top and still have it fire another remote flash simultaneously?

A: Sorry, I can't help. I shoot Canon w/ a Canon flash. I fire my flash remotely using the device on the hot shoe, manual flash only with my particular equipment. B&H customer service has been a great help for some of my questions in the past. You might try them.

Q: 2. Which Yongnuo's controller works with this flash?

A: The Yongnuo YN32-TX TTL 2.4GHz Wireless Flash Transmitter for Sony Cameras B&H # YOYN32TX is the controller you would want for the YN685EX-RF for Sony rom Yongnuo.

Q: 3. Will this fire an off-camera Sony HVL-F43M flash and does it require a receiver for the flash? Camera is a Sony A7iii.

A: No. The following system runs off its own protocol system. Will work only work with the following units mentioned Yongnuo YN650EX-RF, YN685EX-RF, YN685II, YN720, YN685, YN560IV, YN660, YN560III, RF603, RF602

Q: 4. Does it work with sony a6000?

A: Yes, the Yongnuo YN32-TX TTL 2.4GHz Wireless Flash Transmitter for Sony Cameras should work with the Sony a6000 camera. Note Yongnuo does not list specific camera models.

Q: 5. Does it work with YN600-EX-RTII?

A: No, the Yongnuo YN32-TX TTL 2.4GHz Wireless Flash Transmitter for Sony Cameras cannot fire the radio receiver inside of the Yongnuo YN600-EX-RT II.

Q: 6. I have YN568EX and RF605N triggers for a Nikon .. I just bought a Sony a7iii will the YN685EX-RF work with the speedlights I already own?

A: No. YN568EX and RF605N triggers for a Nikon are meant to be used with the Nikon camera so they will not with on your Sony a7III. Yongnuo Ttl Speedlite For Sony BH #YOYN685EXRF will work on your Sony a7III mirrorless camera.

Q: 7. Will these work with a canon 6D to fire a Alienbee400 strobe??

A: Yes, the Vello FreeWave Fusion Basic FWB-24 Wireless Trigger System for Canon may be used to trigger the AlienBees B400 monolight with the Sync Cord 2.5 to 3.5mm Sync Cord included with the trigger system.

Q: 8. Does this flash is compatible with Sony a7 iv?

A: Yes, the Yongnuo YN685EX-RF 2.4GHz Wireless Flash Speedlite for Sony Mirrorless Camera is compatible on the Sony A7 IV.

Q: 9. Will the PC sync connection power out to a pocket wizard to fire other off camera flash?

A: Yes. Via pc to 3.5mm jack.

Q: 10. Will it work Sony A6000?

A: Yes the Yongnuo YN685EX-RF 2.4GHz Wireless Flash Speedlite for Sony Mirrorless Cameras BH #YOYN685EXRF • MFR #YN685EX-RF is compatible with the Sony a6000.