This is a precision-machined 100mm to 75mm Bowl Adapter from Kessler Crane. It allows you to convert a 100mm tripod bowl to a 75mm bowl.

Convert 100mm Tripod Bowl to 75mm    Precision-Machined

Related Questions and Answers

Q: 1. Can this item be secured via suction or must I bolt it to the table on which I wish to situate it?

A: The ProMediaGear 75mm Bowl Adapter (6") is designed to be used with flat head tripod legs. While the adapter could be attached to a suction mount with a 3/8"-16 screw, we would not recommend such a setup due to potential instability with the addition of an attached head and camera.

Q: 2. Will this work with any 100mm bowl tripod? I have the Induro Carbon 8X Video Tripod sticks.

A: Yes, this adapter works with any tripod with a 100mm bowl. I have a Manfrotto 75mm fluid head with a Sachtler 100mm bowl sticks, and its works perfect.

Q: 3. I have a Manfrotto 502 75mm head to use on my Sachtler HotPod. Will this adapter ring do the job for me?

A: This piece will adjust the Manfrotto to the 100mm needed for the Hot Pod.

Q: 4. Does this come with the 100mm bowl?

A: Yes it does.

Q: 5. Does this fit on Manfrotto 528XB tripod legs?

A: Please use the Manfrotto adapter below when using the 528B legs. Manfrotto 319 75mm to 100mm Bowl Adapter BH #MA319

Q: 6. I have a Manfrotto 3141B tripod which has a 100mm bowl. Will this work with it?

A: I don't have your very same tripod, however, in another configuration of using 75mm head on my 100mm tripod, this works perfectly. Perfectly, BTW, means you need to tighten it hard - but yes, this is the right thing for you!

Q: 7. Can I use this 100 to 75mm adaptor on any 100mm bowl?

A: The TRB75 adapter is specifically designed to insert into the ProMediaGear Pro-Stix 42 Series Carbon Fiber Tripod and allow you to use a 75mm or 100mm Bowl. The 100mm bowl will sit a bit higher in the adapter on the top ridgeline. Any 100mm bowl should work with this adapter as well as any 75mm bowl. A 75mm bowl will fit into the dish lower than the 100mm.

Q: 8. Does this work with Sachtler FSB6 head and Manfrotto 528XB legs?

A: Yes, the Manfrotto 319 75mm to 100mm Bowl Adapter would support and work with the Manfrotto 528XB legs to convert the 100mm bowl to 75mm. However, we can not confirm that the Sachtler FSB6 would mount properly and be supported work.

Q: 9. what is the weight capacity?

A: Weight capacity is 100lb.

Q: 10. Will this work on Gitzo systematic Series GT4542LS tripods?

A: The ProMediaGear 75mm to 100mm Bowl Adapter for Pro-Stix Tripods may work with the Gitzo Series 4 Systematic Carbon Fiber Tripod (Long), however we have not tested the combination and can not confirm if it would work or not.