The Screen Works 48" Skirt for the E-Z Fold Projection Screen is a smart addition to any presentation. This skirt helps close the projection area and focuses the viewers' attention on the screen. As it is an opaque barrier, it also provides a secure curtain behind which you can store cases, pamphlets and other material not needed immediately.

The biggest benefit of the skirt is that it helps block distracting light from filtering through the background and disturbing your presentation.

Pleated Velour skirts available with trim kits or stand-alone

Standard height 48"/122cm

Skirts snap to bottom of screens

Perfect accessory for front or rear projection screens

Velour skirts offered in Black, Blue, Gray and Burgundy

Related Questions and Answers

Q: 1. Where is this slider made?

A: The following unit is made in china.

Q: 2. Is this Slider strong enough to slide vertically while holding a DSLR or a mirrorless camera?

A: This slider can perform vertical slides with a DSLR or Mirrorless camera. However it will be in manual mode only, it is not possible motorized.

Q: 3. Does this slider able to pull 23 pound when it set to vertical bottom to top?

A: no this motorized slider will not pull 23 pounds when oriented vertically

Q: 4. Can I mount a camcorder if it is light enough in weight?

A: Yes, the following slider will support a payload of 11 lbs.

Q: 5. What is the maximum load weight for a vertical motorized shot?

A: GVM doesn't specify a load capacity when using vertical mode. A good rule of thumb is to cut the horizontal load by half when doing vertical sliding.

Q: 6. Other than the weight difference, how does the aluminum tube model compare to the carbon fiber model? Is there a difference in strength, durability, vibration, performance, etc?

A: The carbon fiber model is lighter but will hold up to 11 pounds and weights 5 pounds, while the aluminum alloy slider holds up to 30 pounds and weights 6.6 pounds. Under extreme conditions, carbon fiber is prone to become brittle.

Q: 7. Can This Slider extend to a longer length?

A: The slider cannot extend any further.

Q: 8. Mount to light stands?

A: Yes. we suggest to heavy duty stands to make sure it stays in place. Impact Heavy-Duty Air-Cushioned 9.5' Light Stand (Set of 2, Black) BH #IMLS96HABI2K (B&H Kit) https://bhpho.to/3IjPOMy

Q: 9. What is the longest amount of time to travel from A to B

A: GVM ran a test on this unit and they have informed us that it took 1 minutes and 32 seconds from A to B on 1% speed.

Q: 10. Says here that this slider holds up,to,30lbs. Is that correct?

A: yes according to the manufacturer the maximum payload on this device is 30Lbs