The Telex TT-16 is a wireless base station transmitter for IFB or personal monitoring use, operating in the low VHF range from 64 to 68 MHz with a reliable transmission range of over 750'.

The TT-16 offers 16-channel frequency-agile synthesized technology, enabling users to switch RF channels directly from the front panel to avoid interference.

The TT-16 is equipped with a balanced 3-Pin XLR connector and a selector switch for compatibility with Telex and RTS-TW systems, and a 1/4" unbalanced connector for use with Clear-Com hardwired intercom systems.

Portable IFB Wireless Transmitter    Range of 750 Feet    16-Channel Frequency-Agile Operation    Panel Switching to Avoid Interference    Frequency Range 64 to 68 MHz    Dedicated Trim Controls on Inputs    3-Pin XLR & 1/4" Unbalanced Inputs    Telex, RTS-TW & Clear-Com Compatible    Input LED Level Meter    Operate 5 Simultaneous Units in 1 Place

16-channel 64.5 - 67.5 MHz band VHF frequency-agile transmitter base for IFB on-air talent or personal monitoring use with 750' transmission range

Front panel rotary frequency selector knob, headphone monitoring output with dedicated volume control

Input LED bar graph level meter

Simultaneous operation of up to 5 units in same locale

8 tunable frequencies in TV channel 3 band, 8 assigned to channel 4 band for improved interference-free frequency agility

Balanced Switchable RTS Ch.1, 2 and Audiocom, unbalanced ClearCom compatibility

RF power switch with 50mW maximum RF output

Balanced XLR and Unbalanced 1/4" inputs with dedicated level trim controls

Related Questions and Answers

Q: 1. Will the this short handle fit and operate with the TVC-34L at its lowest (on the ground) leg position? Im seeing mixed details about it. It says its a 2.5 handle which should work but, the specs say its 3 which from what I calculate, wouldn't work.

A: The TVC-34L at it's lowest gets the top of the plate down to 4 / 10.16 cm. The Really Right Stuff TA-3 Leveling Base with Short Handle and Platform with 3/8 -16 Stud B&H # RETA3LB MFR # TA-3-LB has a total height (excluding stud): 4.9 / 124mm. The handle on it comes with no hook and is 2.5 / 63.50mm. RRS states these handles do not significantly impact your ability to drop the tripod to ground level. If you are still concerned, RRS has the Really Right Stuff TA-3 Leveling Base with Low-Profile Knob and Platform with 3/8 -16 Stud B&H # RETA3LBLP MFR # TA-3-LB-LP just for you. Its total height (excluding stud): 3.4 / 86mm. Get down baby.

Q: 2. Can this be used with Nikon Z?

A: Yes, the Godox XT-16 will work with the Nikon z series a end-user must be mindful there is no TTL and is a single pin all manual system.

Q: 3. Hi can I used it for gitzo S3 series tripod

A: This combination is unknown and cannot be tested by B&H unfortunately. However, the Really Right Stuff TA-3 can fit on 75mm bowl tripod. The Gitzo GT3533S can take 75mm ball heads so it is only our opinion that it should fit.

Q: 4. Can this be used with Leica Q2 and godox TT685 that is for a Sony a7RII?

A: Yes you can but the flash will only be Manual.

Q: 5. is this compatible with canon t7?

A: Yes, the Godox XT-16 is compatible with the Canon Rebel T7.

Q: 6. Does this work with a Canon SL3?

A: Yes.

Q: 7. Will this work w/Induro CTO14 tripod and Kirk ballhead?

A: No, the Really Right Stuff TA-3 Leveling Base with Short Handle and Platform with 3/8"-16 Stud does not work on the Induro Carbon 8X CT014 Tripod.

Q: 8. Does this multi-viewer support tally?

A: This device does not offer tally light support.

Q: 9. Is this compatible with godox flash TT600?

A: The transmitter is compatible with the built in receiver of the TT600. You would not use the USB receiver.

Q: 10. How many flashes can be controlled/triggered at once with this unit?

A: You may control up to 16 flashes with the Godox XT-16 Flash Trigger.