The Unbalanced Adapter Cable from Remote Audio features a 3.5mm right angle TS connector on one end and a 3-pin XLR male connector on the other. It can be used as an output cable for audio applications from camcorders, DSLRs, and recorders or any other device with an unbalanced 3.5mm mini-jack connector to a 3-pin XLR mixer input or other XLR device. It is built with professional-quality Neutrik and Canare brand components. In addition, the cable is 18" in length.

For Camcorders, DSLRs, and Recorders    18" Length    Neutrik Connectors    Canare Cable

Related Questions and Answers

Q: 1. Will this cable work between the Mozegear D-Mini Papi Red Version and the RED DSMC2 I/O V Lock Expander?

A: You would need to check your components for these connections:Connector 11/8 (3.5 mm) right angle TRS mini-jackConnector 2TA5FIf you are looking to connect a microphone , then this might work, depending upon the pin configuration of your microphone.

Q: 2. A lot of these cables seem to short one of the signal pins to ground, which can cause issues or even damage output circuits. Is this the case here?

A: As our trusted rep from Hosa has mentioned, this is an unbalanced cable with pins 1 and 3 connecting to the sleeve while pin 2 connects to the tip. The Rean connectors used in its construction are pro quality and made by Neutrik. An unbalanced XLR to 1/4" cable like this one has a 1/4" TS connector which won't short the signal when used to connect to an unbalanced input. Avoid using balanced XLR to 1/4" TRS cables, which could cause issues when used to connect to an unbalanced input.

Q: 3. Does this cable work with the Arri Amira?

A: Yes it will work.

Q: 4. picture shows 3.5mm TRS but description says 3.5mm TS which is correct?

A: Yes, the image seems to be incorrect on our website, and Remote Audio's, too. The description is that it terminates to a TS, and mentions that it passes a mono signal, so that would be it.

Q: 5. will this cable work for inputing IFB using Lectrosonics LT transmitter from LiveU 600 ?

A: If your device has an 1/8'' audio output then yes, you can go from that into your Lectrosonics transmitters using the Remote Audio CALEC1/8T5FS cable.

Q: 6. Can I use this with to provide phantom power to two sets of Sennheiser MZA 900 P and Sennheiser ME 3 EW from the powered 3.5mm mic port on a Zoom H4n?

A: These cables will not pass phantom power reliably. They are designed for audio signal only.

Q: 7. Does it pass phantom power? Thanks

A: Yes it does

Q: 8. Does this cable keep the stereo output separated at the 1/8 end or does it sum to mono?

A: The Remote Audio CALEC1/8T5FS's stereo output is summed to mono.

Q: 9. Are these XLR Male connectors nickel, silver, or any plated?

A: These should be nickel plated.

Q: 10. Will this connector work to connect a Countryman Lavalier mic that has a 3 pin XLR connector to connect it to a Sennheiser G2 or G3 wireless lav transmitter?

A: This would not work with a Countryman wired xlr since that specific mic would need 48v phantom power to run, which the Sennheiser transmitter will not provide. It would be recommended to purchase a Countryman mic wired for Sennheiser instead: BH #COB3W4BSR.