The Countryman EMW Omnidirectional Lavalier Microphone is designed to reproduce vocals, musical instruments, and ambient audio sources with pristine detail and minimal handling noise. The capsule is highly resistant to moisture, making it a suitable solution for outdoor use, placement against skin, etc.

Clear audio reproduction with low rubbing and handling noise is a result of the EMW's omnidirectional polar pattern. The flat frequency response is well suited for capturing instruments and general vocals in stage performances, trade shows, houses-of-worship, auctions, lectures, and much more.

A wide variety of colors and connectors are available for use with various wireless transmitters. This version is white and features a 4-pin Hirose connector for use with Audio-Technica wireless transmitters.

Flat Frequency Response    4-Pin Hirose Connector    Moisture-Resistant Capsule    Low-Handling Noise    (White)

The EMW lavalier microphone is available in three frequency response types. This version features a flat response for capturing vocals, various instruments, and ambiance.

The square EMW lavalier is available in various colors that virtually render the entire microphone invisible against the skin, allowing you to select the version that is best suited for your application.

The attached cable is made of durable, break-resistant Kevlar for rigorous use without shorts or wear.

The EMW is credited with providing pristine audio with minimal handling and rubbing noise, due to its omnidirectional polar pattern.

This square, moisture-resistant capsule is ideal for use in humid conditions, on skin, outdoors, etc.

Related Questions and Answers

Q: 1. Can anyone give me the measurement/diameter of the bottom of the base (that base that attaches to the tripod)?

A: As per manufacturer specs: Long edge - 10.4cm/4.09 inches; Short edge - 8cm/3.14 inches

Q: 2. It has the knob on the right to tighten the plate and make sure it doesn't fall. Does it have a another safety lock to make sure the camera and plate doesn't fall off?

A: There is no safety lock on the plate itself. The Manfrotto 500 head has a knob that you twist and lock then you push down to allow the plate to slide on and off. When the knob is tighten and upright, the plate is locked in place.

Q: 3. What is the leveling range of the Leveling Column Kit?

A: It is in the range of approximately 30°.

Q: 4. I have an Induro CLT 204 with a Manfrotto 496RC2 head. Can this fluid head be used with the VH500Ah be used with this tripod?

A: Yes, you would be able to replace the 496RC2 head with the MVH500AH.

Q: 5. Is this tripod allowed in disneyland? it states in disneylnd faq that they allow tripods but not large tripods. Is this considered Large?

A: The Disneyland rule is Folding tripod stands or monopod stands that can fit inside a standard backpack are permitted. The folded length of this tripod and head is about 30 which would require a rather large backpack. My opinion is that probably the Park would allow it but that of course is up to the security staff. You may wish to consider this smaller Manfrotto with the MVH500AH Head, and the MT190XPRO4 Legs. It's folded length is about 25 . Finally, here is a very small yet capable travel tripod and head the Benro Aero 4 Video Travel Angel Tripod Kit which is only 21.7 when folded.

Q: 6. Can you remove the head to use it on a slider?

A: Yes, the head on this tripod kit has a 3/8"-16 thread. You will be able to remove it and put it on a slider.

Q: 7. can this be mounted on any tripod?

A: This has a 3/8"-16 thread which will allow it to be mounted on a wide variety of tripods.

Q: 8. How much is the total weight, tripod with head?

A: The Manfrotto kit comes with two parts. The Manfrotto 500 head weight is 2 pounds. And the legs are 4.3 lb. The total weight of both head and legs would be 6.3 pounds.

Q: 9. Which carrying bag fit with this Manfrotto MT190x3?

A: The combined folded length of this head and leg kit is 27.36 so I would suggest either the MB MBAG75PN (padded) or MB MBAG75N (unpadded).

Q: 10. Will this work with a Sony FDR-AX53

A: Yes it will work fine. how ever I would use a smaller head for that camera.. as this head is pretty large for such camera.. Look for the smaller manfrotto head.... Things to look for are MAX payload.. your camera is approx 1.3lbs and this head is designed for up to 11lbs.. I would look for a smaller head closer to max payload of 4lbs for your style camera...