You are using an outdated browser. For a faster, safer browsing experience, upgrade for free today.
Phones: 800
$ USD
  • Your shopping cart is empty!

Countryman E6 Directional Earset Mic, Medium Gain, With Detachable 1mm Cable And 3.5mm Locking Connector For Akg Wireless Transmitters (tan)

Countryman E6 Directional Earset Mic, Medium Gain, With Detachable 1mm Cable And 3.5mm Locking Connector For Akg Wireless Transmitters (tan)
  • Product Code: ga231458
  • Availability: In Stock

$2,036.85 $2,994.17

The tan E6 Directional Earset Mic, Medium Gain, with Detachable 1mm Cable and 3.5mm Locking Connector for AKG Wireless Transmitters from Countryman is a vocal microphone with an adjustable boom that weighs less than one-tenth ounce. It can be used on either ear for capturing audio and rejecting unwanted sound, feedback, or surrounding noise from stage monitors or nearby speakers in houses of worship, theater, and outdoor vocal and speech applications.

The low-profile, directional E6 Earset virtually disappears against the skin, so performers forget they're wearing a mic. Three sensitivity options cover general speaking to extremely powerful vocals and four color options allow you to match the E6 to your skin tone for minimum visibility.

In addition, the E6 Earset features a pattern-changeable directional microphone for maximum isolation and gain before feedback, but is available as a water- and wind-resistant omnidirectional microphone too. This directional E6 Earset's cable terminates to a 3.5mm locking connector for direct connection to an AKG PT51, PT300, or PT900 wireless bodypack transmitter.

For Vocals and General Speaking    Detachable 1mm Cable    3.5mm Locking (AG), See Description    30 Hz to 15 kHz Frequency Response    Includes Cardioid & Hypercardioid Caps    Headroom for Strong Vocals    Windscreen    Cable Clips    Carrying Case

Key Specs
Compatible TransmittersAKG: PT300, PT500, PT51
Polar PatternCardioid / Hypercardioid
Frequency Response30 Hz to 15 kHz
Maximum SPL135 dB
SensitivityW6/6/Mid Gain for Speaking and Vocals (H6, E6, EM6, EM2)
Analog Output1x 1/8" / 3.5 mm TS Male
Environmental ResistanceWater-Resistant with Included Housing (Unrated)
Microphone
Compatible TransmittersAKG: PT300, PT500, PT51
Polar PatternCardioid / Hypercardioid
Included Tone/Pattern CapsHypercardioid, Cardioid
Performance
Frequency Response30 Hz to 15 kHz
Maximum SPL135 dB
Sensitivity1.9 mV/Pa
SensitivityW6/6/Mid Gain for Speaking and Vocals (H6, E6, EM6, EM2)
Equivalent Noise Level29 dB (A-Weighted)
Connectivity
Analog Output1x 1/8" / 3.5 mm TS Male
Cable Length5' / 152.4 cm
Cable Diameter0.039" / 1 mm
Power
Power SourcesPlug-In Power
Operating Voltage1 to 2 V
Physical
ColorTan
Environmental ResistanceWater-Resistant with Included Housing (Unrated)
Weight0.07 oz / 2 g
Packaging Info
Package Weight0.5 lb
Box Dimensions (LxWxH)10 x 10 x 2"

The Countryman E6 head-worn Earset is small and lightweight, and is hardly visible from a distance.

The E6 Earset's stainless steel boom is built tough and can be bent and re-bent many times to fit different performers. The E6 is highly resistant to makeup, sweat, and moisture when used with the supplied protective caps.

The flexible boom is easily shaped right on the performer's face and is available in multiple skin tones. Their protective caps let you shape the frequency response for different situations or to match other microphones; caps for the directional earset adjust the pattern from cardioid to hypercardioid. Choose a sensitivity for speaking or singing with up to 145 dB SPL capability.

The E6 provides high-quality audio with low distortion and an SPL of up to 145 dB. It delivers rich, full band audio quality.

Easy adjustment keeps the mic in a position for rejecting unwanted sounds. Countryman's omnidirectional Earset offers a reduction of 12 dB compared to a lavalier mic, while the directional E6 Earset provides even more isolation. Excellent for houses of worship, theater, and outdoor events.

An E6 replacement cable installs in seconds. The snap-on cables are rugged and available for almost any wireless transmitter or for XLR inputs with phantom power.

For speaking and vocals.

Related Questions and Answers

Q: 1. Does this unit work on the Nikon D3100?

A: The Vello Shutterboss II for Nikon 10-Pin is not compatible with the D3100. For the D3100, you would need the following intervalometer: Vello Shutterboss II for Nikon with DC2 connection (B&H# VERCN22).

Q: 2. Would this sync the shutter and flash on a multiple camera setup using a wireless HSS flash system like Godox? I tried using a wireless Godox trigger/receiver but the flash does not sync with the shutter across multiple cameras.

A: I contacted Vello Gear concerning your inquiry. According to Vello Gear, they state if the Vello Wireless ShutterBoss II Receiver is connected to the remote terminal of your camera via a remote shutter release cable, and both the ShutterBoss II receiver and the handheld ShutterBoss II transmitter are set to the same channel, then yes, it may trigger multiple cameras whose receivers are also set to the same channel. However, that being said, the ShutterBoss II transmitter and receiver are not compatible with Vello's Freewave flash transmitters/receivers, nor is it compatible for use with Godox flash transmitters/receivers, and will not wirelessly trigger Godox products or flashes connected to Vello Freewave remotes.

Q: 3. Will this control video start and stop on A6000?

A: Yes this would be compatible with the Sony Alpha A6000

Q: 4. Is there an adapter to change the 3-pin to a sub mini pin or visa-versa? Older camera & newer camera, but only need one Timer Remote.

A: No this is made for a specific camera you have to find one that fits and is made for your camera the lists of cameras it will fit are always stated

Q: 5. Will this remote work with a Nikon D3000 and how long is the cord/cable?

A: Unfortunately, as the Nikon D3000 DSLR camera does not have a MC-DC2 remote terminal, the Vello Shutterboss Version II Timer Remote Switch for Nikon with DC2 Connection cannot be used with the Nikon D3000 DSLR camera. The Nikon D3000 does not have a remote terminal; it is only compatible with infrared wireless remote controls, such as the Nikon ML-L3 Infrared Remote, B&H # NIMLL3, or the Vello IR-N1 Infrared Remote Control for Select Nikon Digital Cameras, B&H # VEIRN1.

Q: 6. Does not work on Sony A7riii?Have it and it doesn't!

A: This would be compatible with the Sony Alpha A7R III

Q: 7. Does it work with the A7iv?

A: Yes Vello ShutterBoss II Timer Remote Switch for Sony Multi-Terminal is compatible with the Sony A7iv.

Q: 8. Does this remote fit the Nikon D5300?

A: Yes, this remote is compatible with the Nikon D5300.

Q: 9. On the Canon 90D, the built in interval timer is disabled in live view (mirror up). I want to do 50 1 sec exposures of night sky in quick succession, but the mirror can cause vibrations. Will this work with mirror up / bulb mode?

A: Yes.

Q: 10. Will this remote work with the new Fuji X-E2 camera ?

A: Yes, the Vello Shutterboss Version II Timer Remote Switch For Canon with Sub Mini Connection is compatible with the Fujifilm X-E2.

There are no reviews for this product.

Write a review

Note: HTML is not translated!
    Bad           Good
Captcha

Top Bestselling Products

Akg Hc644 Head-worn Microphone

$945.00 $1,341.90

Products You May Like

Luminex Luminode 2

$2,767.50 $4,040.55

Countryman Isomax 2 All Purpose Microphone

$1,044.00 $1,357.20