The RF-Video AMP-5000M is a high power microwave amplifier for use with any transmitter broadcasting in the 2.4 GHz frequency. Amplified wireless signals translate into improved video and audio quality transmissions over greater wireless distances. Its durable design and its ability to tolerate high and low temperature extremes make it particularly well suited for use in military monitoring applications.

Disclaimer: RF amplifiers for 2.4 GHz and other frequencies marked as "unidirectional amplifiers" can be used for one-way amplification only. They are not valid for digital microphone systems (such as Zaxcom and similar wireless microphone systems) because such systems employ two-way communication from the base station to the handheld unit. Connecting a unidirectional amplifier to a wireless microphone's base station will cause attenuation of the receiving signal. This is due to the fact that the base station and handheld unit employ two-way communication, and the signal cannot be received due to the amplifier's simplex operation. A duplex operational amplifier or bidirectional amplifier is required for digital microphone systems.

Unidirectional microwave amplifier for use with 2.4 GHz transmitters

Thermal protected design ideal for military applications

12-14 VDC battery operable

10mW minimum power input, 5 Watts maximum power output

Built-in microwave filter

Low noise design

Accepts SMA type antenna

Related Questions and Answers

Q: 1. Will this work on the 600CSA lights?

A: No. The system runs off a different protocol system. Please review the following for your bluetooth needs Sidus Link

Q: 2. Will the camera read what F stop is being used on the camera or does it just show "F--" when attached?

A: camera will not read the f/stop from the lens.

Q: 3. Which Yongnuo's controller works with this flash?

A: The Yongnuo YN32-TX TTL 2.4GHz Wireless Flash Transmitter for Sony Cameras B&H # YOYN32TX is the controller you would want for the YN685EX-RF for Sony rom Yongnuo.

Q: 4. Will this device control a Forza 500 'out of the box', or do I need to add some other piece of equipment?

A: This BH #NAWSRCC2 is directly compatible with the Forza 500.

Q: 5. Is there a setting I need to change on my camera for this lens to work? I just got it in the mail and the shutter won't click. I have the camera in Manual.

A: Yes, you need to change a setting. In the menu, in the custom function section ( it's an icon of a camera with little hash marks under it ) navigate to C.Fn III-7 Release Shutter Without Lens. The options are 0 disable 1 enable. Switch to enable. This information is on page 544 of the manual: http://gdlp01.c-wss.com/gds/3/0300033693/01/eosrp-ug-en.pdf

Q: 6. Does this work with evoke 1200?

A: No. The evoke 1200 can only be driven by on-board, bluetooth, dmx, rdm, lumen radio and hardline wire control.

Q: 7. Will the PC sync connection power out to a pocket wizard to fire other off camera flash?

A: Yes. Via pc to 3.5mm jack.

Q: 8. what's the difference between the WSRCC2 and the RC-2 for controlling a Forza 60B?

A: There is no difference in using ether remote, Nanlite Nanlink 2.4 GHz Remote Control or Nanlite RC-1 Bi-Color Remote Controller when using those with the Forza 60B. The Forza B is not RGB.

Q: 9. Does this flash is compatible with Sony a7 iv?

A: Yes, the Yongnuo YN685EX-RF 2.4GHz Wireless Flash Speedlite for Sony Mirrorless Camera is compatible on the Sony A7 IV.

Q: 10. Will this control a Nanlite MixPad II 11c?

A: This will not control a MixPad IIc.