The SKB 3I-0907-6-E Small Mil-Std Waterproof Case 6" Deep (Black, ) is an injection molded ultra-high-strength polypropylene copolymer resin case. It features a gasketed, water- and dust-tight, submersible design that is resistant to UV, solvents, corrosion, fungus and impact damage. The case is ATA category 1 rated. There is a continuous molded-in hinge, a "trigger release" latch system, a comfortable, snap-down rubber overmolded cushion-grip handle, and an automatic ambient pressure equalization valve. The case is lockable with a customer supplied padlock.

This case has an empty interior.

Polypropylene Copolymer Resin Case    Gasketed, Waterproof and Dust-Tight    ATA Category 1 Rated    Continuous Molded-In Hinge    Trigger Release Latch System    Automatic Ambient Pressure Valve    Rubber Cushion-Grip Handle

Injection molded, ultra-high-strength polypropylene copolymer resin case

• ATA (Air Transport Association) category 1 rated
• MIL-STD-810F Military specification for resistance to UV, solvents, corrosion, fungus and impact damage
• MIL-STD-C-4150J Military specification for waterproof and water-vaporproof cases for transit and storage
• IP67 Military specification for protection against dust and against the effect of immersion between 15cm and 1m
• MIL-STD-648C Military specification for automatic ambient pressure equalization valve

Trigger release latch system is lockable with a customer supplied padlock

Continuous molded-in hinge for added protection

Temperature rating = -40 to +160°F (-40 to +71.11°C)

Snap-down rubber overmolded cushion grip handle

Related Questions and Answers

Q: 1. Will this fit a Canon 80D?

A: The Canon EOS 80D DSLR Camera will fit in the DiCAPac WP-S5 Waterproof Case for Small DSLR Cameras. Make sure the lens you are using is 2.0-3.75" in length and up to 82mm in diameter.

Q: 2. Will it fit my canon eos 1200D

A: Yes, it can. What may hinder your use of this bag is the size of your lens, as long as it is under 3.75 long, you will be able to use this.

Q: 3. Hi, does it fit Nikon D750 and Nikkor 17-35 pls?

A: No, it would not; it would be slightly too small for your listed equipment. DiCAPac lists the DiCAPac WP-S10 Waterproof Case, B&H # DIWPS10, is recommended for use with the Nikon D750 DSLR camera.

Q: 4. Will it fit a Canon 6d with Sigma Art 35mm? Thanks

A: The case fit my large Nikon. I do not use it anymore because the plastic on the front showed many imperfections in photos ( like rainbows and distortions from the plastic)

Q: 5. Will a T5i fit?

A: The Canon T5i will fit in the DiCAPac WP-S5 Waterproof Case. You do have to use lenses that are from 2.0 to 3.7 in length.

Q: 6. would this bag fit a fuji x-t1 and a 23mm lens? the dicapac wp-s3 will not fit the 23mm lens.

A: I don't have the 23mm.... But the kit zoom lens 18-k5mm fits and zooms to full on a x-t1

Q: 7. Will this fit the Panasonic Lumix FZ1000? Or do I need to get the WP-S10?

A: I think It will... In this case, I was able to fit a Canon 6D with a 35 mm lens. I think the Panasonic body is smaller than the 6D, and I think there is enough space for the lens too.

Q: 8. Does this fit a Nikon Coolpix L830?

A: Dicapac actually makes an underwater bag for mirrorleas cameras. That might be a safer bet since the coolpix l830 seems the same size as most mirrorless cameras. That way you wont have to worry about too much excess room in the case making it difficult to hold the camera in place.

Q: 9. I have a Panasonic FZ80 which does not have a removable lens. Will that fit into the mouth of the WP-S5 bag? Also, will the case accommodate the fully extended telephoto lens?

A: The FZ80 will fit in the DiCAPac WP-S5 Waterproof Case for Small DSLR Cameras. But you can not extend the zoom lens fully.

Q: 10. can this product be used with canon 60D and lens 18-200 mm ?

A: According to DiCAPac's fitting guide, they state the larger DiCAPac WP-S10 Waterproof Case, B&H # DIWPS10, would instead be the correct case for use with the Canon EOS 60D DSLR camera.