The BPA60 from Bogen is a solid-state, 60W power amplifier that has been designed for professional and commercial sound systems. It can be driven from an amplifier that provides a 25- or 70-volt output and is thermally protected to prevent damage due to excessive temperatures.

Additional protection for the amp is provided by transient protection diodes and an electrical circuit breaker. The illuminated on/off power switch is located on the front panel. An input level control, circuit breaker reset, low-cut filter switch, and auxiliary receptacle are located on the rear panel.

60W Rated Output Power    Distortion: Less Than 2% THD    Transient Protection Diodes    20 Hz to 20 kHz Frequency Response    8 Ohms/25V, 16-Ohm, 25V CT, 70V Output    -10 dB at 100 Hz Low-Cut Filter    Resettable Circuit Breaker

Selectable outputs modes of 8-ohm/25V, 16-ohms, 25V CT, and 70V

The BPA60 can operate at full output even with ambient temperatures up to 130°F

Related Questions and Answers

Q: 1. What is the guide number when both bulbs are at full power?

A: Unfortunately, the manufacturer does not list that information. Using two Godox AD200 TTL Pocket Flashes at full output would output 400W of power, but the guide number for two units used simultaneously is not listed.

Q: 2. Will it function with one AD200 unit and two bulbs attached?

A: Yes it will

Q: 3. How do you know which parabolic softboxes will work with this bracket? I'm looking for a 25" to 26" parabolic softbox that will be compatible.

A: The mount is a Bowens mount. Any softbox with a Bowens mount will work. This one is 26" https://bhpho.to/2ORnF8D.

Q: 4. Can this be used as a constant light?

A: This is strictly for use with the Godox AD200/AD200 Pro flash heads.

Q: 5. How bright are the modeling lights?

A: The modeling lamps on the AD-B2 are about 20 watts each.

Q: 6. Will this work with Godox H200 R round flash heads?

A: The Godox Dual Power Flash Bracket for AD200 gives the user a Bowens S mount to mount many modifiers while using the Godox AD200 flash. If one wishes to use the Godox H200 R round flash head, it will work with the Godox AD200 flash unit, without the dual power bracket connected.

Q: 7. If I wanted to leave 2 ad200 lights and their bulbs mounted on the bracket, what could I use for bulb covers?

A: Any Bowens deep cover will work just fine. If you can't find one here, try Adorama; search for Flashpoint XPLOR 600 Protection Cover.

Q: 8. Does this function with only a single AD200 body/bulb attached?

A: Yes, 1 or 2 AD200's.

Q: 9. Can a Godox AD200 TTL Pocket Flash be combined in this Godox Dual Power Flash Bracket with another Godox AD200Pro TTL Pocket Flash ..?

A: Yes.

Q: 10. What is the total weight of two attached AD200 with batteries when combined with this bracket?

A: Total weight is about 4.5lbs.