The 24799V Da-Snap 87 x 139" Fixed Frame Screen from Da-Lite is designed for wall and wall-recessed installation.

164" Diagonal / 16:10 Aspect Ratio    HD Progressive 1.3 Surface    1.3 Gain / 150° Viewing Angle    Square Aluminum Tubing Frame    Black Backing

Ideal for applications where projector brightness and screen size require an increase in gain, the white surface offers high-fidelity color reproduction, and allows for more flexibility with ambient light conditions. This surface works for video as well as charts and graphs in a corporate setting. Cone 150° Gain: 1.3

Related Questions and Answers

Q: 1. how much 3D print befor the cartridge runs out of ink? (assuming full yellow color of 3d print)

A: Unfortunately there is no way to predict how long it will last because there are too many variables such as object size and the amount of yellow your object needs.

Q: 2. How much prints can I do with a single ink cartridge?

A: Unfortunately there are too many variables such as the size of the object and the amount of yellow ink you need.

Q: 3. Does The Da Vinchi Jr. 1.0w come with filament?

A: No, there is no filament included with the printer.

Q: 4. I was given a new unit and I need a cord Could you give me a part number?

A: The XYZ power coed is not available at B&H.

Q: 5. How do you get the laser?

A: Unfortunately, B&H doesn't carry the engraver module for this model. Sorry for any inconvenience. You can use the link below to purchase it directly from XYZprinting. https://bit.ly/2J23BeM

Q: 6. How does this compare to the Sachtler flowtech 100 MS Carbon Fiber Tripod?

A: The Sachtler flowtech 100 MS Carbon Fiber Tripod with Mid-Level Spreader & Rubber Feet (BH #SA5585) has a payload limit of 66 lb, where as the Sachtler CF-100ENG 2CF Carbon Fiber 2-Stage Tripod Legs (100mm Bowl) - Supports 88 lbs can support up to 88 lb. The 100 MS also has a single leg lock point vs the 2 leg lock points of the CF-100ENG. The overall leg design is different as well.

Q: 7. Is there a writing area in each page?

A: Yes, on the inside closest to the bindings.

Q: 8. Can you replace the glass bed on the Jr 1.0? How?

A: Scott is correct

Q: 9. HOW DOES IT PRINT OBJECTS WITH LARGE OVERHANG ? WHAT I MEAN IS , CANTILEVERED...DOES IT REQUIRE SUPPORT MATERIAL FOR THE OVERHANGING PART?

A: The build volume is maximum: 5.9 x 5.9 x 5.9 material. It does not require support for large overhang. You will need to experiment to see what the filament support limit is.

Q: 10. If I hook this up to my vocopro jamcube will I be able to change the key on my music both for CD+G and BT streamed music? Or will only change the Key for CD's?

A: The VocoPro DA-2200 Pro Six-Microphone Karaoke Mixer is a simple microphone mixer and CD+G karaoke player router. So any key changes would have to be done by your vocopro jamcube.