The Newcon Optik NC BURD Back-Up Red Dot Sight is a tactical backup reflex sight, and is an optional accessory for the NC 4x32 and NC 6x50 fixed sights. The NC BURD allows rapid target acquisition at close range.

• Rapid target acquisition
• Eliminates the need for a separate 1x capable scope
• Easy to use
• Waterproof and fog proof

Related Questions and Answers

Q: 1. Will this fit on a Kimber Super Carry Pro HD 45 ACP?

A: I can only confirm that the manufacture has stated: This Dovetail Mount replaces the rear sight on Kimber 1911 and Ultra Carry pistols in order to mount the Trijicon RMRcc Red Dot Sight. Professional installation is recommended.

Q: 2. will this sight fit on my rock island 22tcm pistol?

A: Unfortunately there is no mount for the Trijicon RM02 RMR Type 2 LED Reflex Sight to be mounted on a Rock Island TCM. About your only choice would be to take it to a qualified gunsmith. Have him install a picatinny rail or mill the slide for a dove tail mount.

Q: 3. Will it fit on a S&W M&P pistol?

A: I purchased the FastFire III w/picatinny mount, but ended up removing the Picatinny and purchasing the mount specific to my Ruger Mark III. Much cleaner lower profile installation. I believe there is a S&W mount. Threaded portion slides into dovetail then mount attaches with 2 or 3 screws. Easy..no gunsmith required.

Q: 4. WHat kind and size of Image Intensifier Tube does this device have? Is it a "Fat ANvis" 43mm tube? non inverting?

A: In its published specification, Newcon only states Intensifier Tube 1 x Gen 2+

Q: 5. Hi I just want to know where I can use 'counter weight'

A: On the helmut Check out the video on Newcon website: http://www.newcon-optik.com/products/night-vision-system/nvs-9-3ag/

Q: 6. I've owned mine for about ten years hasn't been used in some time. when I press the generator I see a couple of small light flashes and that is all. It is a newcon optic M 2.0x 1st generation night vision monocular. does anyone know what might be wrong?

A: Might be defective or you might have to replace a part in the device. I would recommend contacting Newcon directly with this inquiry to see if your device needs to be sent in to be serviced. Tel: (416) 663-6963 Email: customerservice@newcon-optik.comWebsite: a href= http://www.newcon-optik.com/ target= _blank http://www.newcon-optik.com//a

Q: 7. Does it come with mounting screws?

A: Yes it does. The site itself fits snug, however the supplied torx screws draw it right where it seats properly.

Q: 8. Does this optic WITHOUT the mount still come with mount screws?

A: The Blackmagic Design Studio Converter BH #BLSCN • MFR #CINSTUDMFT/H/SC does not come with any screws.

Q: 9. If the slide has been cut for an RMR do the screws fit?

A: Cannot guarantee that the screws will still fit.

Q: 10. Can this be mounted on a camera's hot shoe?

A: There is no hot shoe or adapter mount available.