The Gator Cases G-PRO-8U-19 8-Space Rotationally Molded Rack Case (Black) is a roto-molded polyethylene case with 19" rackable depth. It has front and rear removable lids and front and rear rack rails. The case has recessed Penn-Elcom twist latches and a stackable outer case design. It is carried by molded-in, ergonomic side handles.

This case is made in the USA.

Roto-Molded Polyethylene    Removable Front and Rear Lids    Threaded Front and Rear Rack Rails    Recessed Penn-Elcom Twist Latches    Stackable Case Design    Molded Side-Carry Handles    Made in USA

• Roto-molded polyethylene
• Removable front and rear lids
• Front and rear rack rails
• Recessed Penn-Elcom twist latches
• Heat-treated 10/32 screws with protective washers included

19" rackable depth

Stackable outer-case design

Molded-in, ergonomic side-carry handles

Case is made in the USA

Related Questions and Answers

Q: 1. Is the interior height (bottom where the camera sits) 9 inches? Also will it fit an assembled fx6?

A: Yes the interior height is 9 inches. Yes, a full assembled fx6 kit can fit in this bag.

Q: 2. Is there another diffuser inside the box, or just the outer diffuser?

A: No. The following unit does not come with an inner baffle system.

Q: 3. Will it fit Sony FDR-AX100?Will it require plastic bag around it while raining?

A: Yes, it will fit a Sony FDR-AX100 and you will have a lot of room left over. I do recommend a plastic bag around it if it is raining. The case is a very nice size case.

Q: 4. What is the Width and Depth Please?

A: This is a new item and the manufacturer only specifies its as a 36" strip.

Q: 5. Can this bag hold a C300 II with the handle attached?

A: I am using it for a C300 Mark II. It works and is a snug fit with the handle, a short shotgun mic and the small monitor that comes with the C300 Mk II attached. I like the bag a lot, but wish it had just a little bit more headroom (height). You can remove the partitions so there is plenty of width and length is good, if you have a short shotgun mic attached.

Q: 6. Are the clips on shoulder strap and the red rings on the bag made of metal or plastic ? And is the outside material of the body water-resistant ?

A: The red rings are made of metal....the clips plastic. I use it to carry my Alexa Mini....it's a tough bag. water resistant. ..not water proff.

Q: 7. How to disassemble

A: To collapse the MagMod MagBox Pro 24" Octa, pull up evenly on the grab tabs in the center of the ring.

Q: 8. I ONLY HAVE 2 CANON EXRT 600 SPEEDLITE. IS IT TOO SMALL FOR 36 AND 42 MAGBOX?

A: 36 inch is more ideal for two dedicated flash units.

Q: 9. How much does this weigh? J. Payne

A: As per MagMod, the MagMod MagBox Pro 42" Octa weighs 2.8 lbs.

Q: 10. What are the dimensions of the medium bag?

A: Sorry, we are not sure of which bag you mean. Please write us at provideo@bhphoto.com.