The Dalite 87 x 139" Advantage Tensioned Electrol Motorized Front Projection Screen is unique in its design. It is manufactured to be installed during the construction phase of your media, class or board room. Afterwards, the fabric is added to complete the set-up. This stylish ceiling recessed screen is for those who don't want the screen showing when it is not immediately needed but available at the flip of a switch. The concealed design of the Advantage Electrol gives it an edge over similar screens in its category.

For easy installation, the Tensioned Advantage Deluxe is available with optional SCB-100 and SCB-200 (RS-232 serial control board) or optional Low Voltage Control unit built into the case.

Ceiling Recessed    Tensioned    164" Diagonal    16:10 Format    16:10 Aspect Ratio    Cinema Vision HC Finish

Handsome white powder coated closure doors and case provide a clean look and allow easy installation of ceiling tiles

Front projection surfaces standard with black backing for opacity

Quiet operation

Case put in during the "rough-in" stage

Patented in-the-roller motor

UL plenum rated case

Related Questions and Answers

Q: 1. Sony has two flash shoe configurations, an older proprietary, and a newer universal. Will the TTL interface work with the newer Sony shoe as on a Sony A7 camera?

A: I would put the question to the manufacturer. My cameras are Canon and my flash is configured to use all the Canon features.

Q: 2. Does it work with the Canon 5D Mk iv?

A: Yes it does. Works with Canon 5D Mark iii too.. and the ringlite comes with 3 adapter rings so that you can use them on different lenses too - for 67mm 72mm and 58mm if im not wrong. Will have to check.

Q: 3. Is this macro ringlight compatible with the Canon 6D?

A: Yes.

Q: 4. Warranty

A: Included is a Limited 1-Year Warranty from Yongnuo.

Q: 5. Will this fit if you’re using a reversing ring? (16-35 mm reversed)

A: If you are using a lens revered there won't be anywhere for the flash to hold onto in the front of the lens, but you could hold the flash with your other hand if possible.

Q: 6. My tamron macro filter is 55mm, what can i do?

A: Use a step up ring to one of the sizes it comes with.

Q: 7. Does this work with the Canon 1DsMark II?

A: Yes, this will work with the Canon EOS 1DS Mark II as they both use the Canon E-TTL II protocol.

Q: 8. I have one of these I purchased at B&H but cannot seem to get it to work now. It won't fire either with the pilot button or on my Canon 7D mkII. any advice?

A: where can I get it serviced? I cannot figure it out on the yongnuo site

Q: 9. Is this flash compatible with Canon EOS r5?

A: Yes, this is compatible with the Canon R5.

Q: 10. Do you have an adapter that will fit the 77 mm thread on my canon f4 24-70?

A: Device comes with 4 adapters. 52mm, 58mm, 67mm, 72mm. A lens with a 77mm thread will be too big to go through the opening, which measures approx. 72-74 mm.