The Dalite 69 x 110" Cosmopolitan Electrol Front Projection Screen is a good, solid and reliable choice for school, business or even home use. This screen is a good choice when either your site, budget or demands do not require a permanently recessed installation. 

The built-in motor is quiet and offers reliable and smooth service. The tensioned version of this screen offers a guide cable that maintains even horizontal pressure to hold the surface flat while a custom slat bar with added weight maintains the vertical tension. Its handsome white case blends with any decor.

Dalite offers projection screens for all scenarios - business, education or social. Manual or electric, large or small, wall, ceiling or tripod style - Dalite has a style to suit everyone's needs.

The Silent Motor feature assures ultra quiet operation - a must for schools, libraries, hospitals and corporate boardrooms.

Wall or Ceiling Mount    Non-Tensioned    130" Diagonal    16:10 Format    16:10 Aspect Ratio    Matte White HC Finish    Front Projection    Silent Motor    With Low Voltage Controller    120V, 60Hz

Handsome white textured case blends with any decor

Standard with a Decora style three position wall switch

UL Listed

Optional floating mounting bracket allows screen to be mounted onto a wall or ceiling studs and aligned left or right after installation by releasing two sets of screws

All fabrics are seamless

Related Questions and Answers

Q: 1. I have a Sony A58 - does this need a hot shoe adapter?

A: This attaches to your camera using a standard hot shoe. But if your camera does not have a hot shoe this unit also comes with its own little stand too be used on a flat surface like a nearby table. You can also just handhold the unit or velcro it to your tripod if necessary.

Q: 2. The spec says the ring has the flash mode triggered from camera. Would it work with Sony A99 via hot shoe?

A: Yes, the Bolt VM-110 is compatible with the Sony A99.

Q: 3. Will this fit on a Sony A77?

A: You would need an adapter to use the Bolt VM-110 LED Macro Ring Light on the Sony A77, such as the Vello Sony Hot Shoe to Standard Hot Shoe Adapter (B&H # VEHSACSC).

Q: 4. Will this ring light properly mount on the hot shoe & sync with my Panasonic GH3?

A: Yes, this ring light will mount on your cameras hot shoe, and comes with lens filter adapters in every conventional size from 49-77mm. There is no sync issue as this is a light, not a flash, so it is the same as shooting in any situation with available light.

Q: 5. Can I use this if I already have a polarizing filter already screwed on to the front of my lens? I'm unclear on how it attaches.

A: I don't see the problem. The flash attach to its own ring that can go after the polarizing lens. All lenses have screw on both sides to allow this kind of connection. You just have to pick the proper flash adapter diameter wise according to your lens diameter.

Q: 6. Will this work on the Nikon D610 with a 28-300mm lens (77mm)?

A: Yes, the Bolt VM-110 will work on a Nikon D610 with a 28-300mm lens.

Q: 7. Is the bolt compatible with a canon power shot g15?

A: Yes with Canon FA-DC58D Filter Adapter for PowerShot G15

Q: 8. Will this work with a Pentax K-30 Camera?

A: Yes, the Bolt VM-110 is compatible with the Pentax K-30.

Q: 9. At maximum illumination and room temperature, how long can this provide continuous illumination for?

A: The manufacture does not list the maximum power used to run it. It runs on four AA batteries.

Q: 10. It will work witn Canon 5D mark IV ?

A: Yes this ringlight is compatible with the Canon 5D Mark IV and a lens with a front diameter of 49, 52, 55, 58, 62, 67, 72, and 77mm.