The Cable Techniques CT-PT3LT2-24 - TA3F to 2x TA5F Connectors (24") is designed to connect the Tape Out of Sound Devices 664, 552, 302, 442 to two (2) Lectrosonics transmitters. The cable itself is a Mogami.

1x TA3F to 2x TA5F    24" Long    From Sound Devices Tape Out    To Lectrosonics Transmitters

Related Questions and Answers

Q: 1. Can this handle 4k RAW from a sony FS5 into an Atomos recorder?

A: Yes it should.

Q: 2. Will this work with a Zaxcom rx200 reciever?

A: Yes, the Cable Techniques CT-LPST5A3M-24 LPS Low-Profile TA5F to Dual Right-Angle XLR3M Y-Cable is compatible for use with the Zaxcom R200 Wireless Receiver which has a TA5 (5-pin mini-XLR) output connector.

Q: 3. Would these cables be compatible with the Sound Devices XL-AES expander?

A: No, the Cable Techniques CT-PXFT-18 XLR-3F to TA3F Cable for Sound Devices is not compatible for use with the Sound Devices XL-AES 8-Channel AES3 Input Expander. The XL-AES has four TA3F inputs, so you will need a cable that has TA3M connectors. To connect to the TA3 inputs on the XL-AES, you can use the single Cable Techniques XLR 3-Pin Female to TA3 Male Cable - 20" (B&H # CACTFXMT320), which is also available in a 2-pack (B&H # CACTF3MT3220), or the single Kondor Blue Mini-XLR Male to XLR Female Audio Cable - 16" (B&H # KOMXLR16BK), which is also available in a 2-pack (B&H # KOBMXLRMF16B).

Q: 4. Is this wired for and will it work to power a smallhd ac7 from a Sony f5

A: I'm using this to power up my lectrosonics transmitter via battery bud with a NP-1 battery.If your F5 has an external power source and has a hirose plug for that job, than yeah ot should be able to power up a small ac7

Q: 5. Each of the TA5F ends receives a summed L/R mono - correct? Just confirming this does NOT separate left from right.

A: The Cable Techniques CT-P35RLT2-24 DOES in fact split left and right channels between the two TA5 connectors. The purpose of the cable is to enable transmission of a L/R stereo mix from a 3.5mm source.

Q: 6. What resolution does this support? Is this 75 or 50 ohm?

A: This would be a 75 ohm cable for use with monitors and EVFs at up to 1080p 60fps resolution.

Q: 7. Even though it is not listed in the information for the product, but will this work with the direct outputs of the sound devices 442?

A: Yes, the Cable Techniques CT-PTXR-18 cable will work with the TA3 direct outputs of the Sound Devices 442.

Q: 8. Would there be any issue with using this to connect a Sennheiser G4 receiver to the input of Blackmagic Pocket 4K?

A: The Blackmagic Pocket 4K is not compatible with the Cable Techniques Mini TRS to TA3F Low-Profile Wireless Line Input Cable (18").

Q: 9. Is this cable balanced or unbalanced?

A: Yes this cable is balanced

Q: 10. can i get it in 3 meter length ?

A: These low-profile type cables from Cable Techniques currently only come in short sizes, because they are designed to connect to field recorders and mixers and take up less space in bags. We do sell the connectors, and bulk XLR cable, if you would like to make your own longer cables.