The Dalite 52 x 92" Cosmopolitan Electrol Front Projection Screen is a good, solid and reliable choice for school, business or even home use. This screen is a good choice when either your site, budget or demands do not require a permanently recessed installation. 

The built-in motor is quiet and offers reliable and smooth service. The tensioned version of this screen offers a guide cable that maintains even horizontal pressure to hold the surface flat while a custom slat bar with added weight maintains the vertical tension. Its handsome white case blends with any decor.

Dalite offers projection screens for all scenarios - business, education or social. Manual or electric, large or small, wall, ceiling or tripod style - Dalite has a style to suit everyone's needs.

Wall or Ceiling Mount    Tensioned    106" Diagonal    HDTV Format    16:9 Aspect Ratio    DA-Mat Finish    Front Projection    220V, 50Hz

Handsome white textured case blends with any decor

Standard with a Decora style three position wall switch

UL Listed

Optional floating mounting bracket allows screen to be mounted onto a wall or ceiling studs and aligned left or right after installation by releasing two sets of screws

All fabrics are seamless

Related Questions and Answers

Q: 1. Will I be able to connect the following cameras to it? Canon T2i, Canon 5D mkiii and Sony AR7 series? Lastly can i swap the batteries on the slider without stopping it or interrupting the shots while doing a time lapse? If batteries are swapped will the settings need to be reset?

A: Your Cameras will work. You can Hot Swap the batteries one at a time the slider draws power from only one battery at a time. Make Shure your batteries ae fully charged before you start.. The longest time lapse is 22 minutes. The fully charged batteries should last about 10 hours.

Q: 2. How many seconds does it take for it to go from one side to another on the slowest setting thats still smooth?

A: this will vary based on your specific settings on the motors so there is no absolute answer as to how much time the slider carriage takes

Q: 3. Why doesn't shutter activate via the shutter release cable when connected to the Fuji XT-3?

A: The electronics inside the slider will need to support and communicate with Fuji's XT-3 camera in order to activate the shutter. This would need to be updated through a firmware update through the manufacturer, if/when they enable support for electronic communication with the Fuji XT-3.

Q: 4. can use for phot 360 with nikon z6II?

A: The Vello FreeWave Orbit Motorized Pan Head with Remote and MPH-P8 Plate Kit is compatilbe with the Nikon Z6ii camera for 360 photography.

Q: 5. I watched a YouTube review that stated it won’t work with Sony cameras. Will it work with a Sony A7iii?

A: you can mount any camera on it but it will not trigger or control Sony cameras, As long as you do not need to trigger or control the camera it will be ok

Q: 6. How many seconds does it take for it to go from one side to another on the slowest setting and the fastest?

A: The amount of time it would take on the fastest speed is 39s , and on the slowest speed it would be 5min and 37s

Q: 7. are the chargers 220V compatible?

A: yes this product will support 120/220v power

Q: 8. can syncro flashes in each shot of camera?

A: The hot shoe of he camera does not connect to the Vello FreeWave Orbit Motorized Pan Head with Remote and MPH-P8 Plate Kit. So using a flash attached via the hotshoe of the camera will work.

Q: 9. Will it work with the Canon T3i?

A: Yes, this system is compatible with the Canon T3i.

Q: 10. How do you control this using Bluetooth? Is there an app you need to download?

A: The slider connects to the remote control using Bluetooth.