The Soul Food from Electro-Harmonix is an overdrive and clean boost pedal designed for the tone conscious player who needs to cut through a mix without altering the voice of his or her instrument. The Soul Food delivers a wide range of sounds from a clean boost for added volume to slightly dirty for added grit, or full-on overdrive. With plenty of volume on tap to push your amplifier into saturation, the Soul Food delivers distortion that is actually created by your amp. In addition, an internal bypass mode switch allows the pedal to function with either true or buffered bypass.

The Soul Food comes equipped with an Electro-Harmonix 9.6DC-200BI power supply and requires 22mA at 9 VDC with a center negative plug. It also accepts a 9V battery.

For Electric Guitar    Transparent Overdrive    Boosted Power Rails for More Headroom    LED Indicator    1/4" Input & Output Jacks    Selectable Buffered & True Bypass Modes    Includes DC Power Supply

Boosted power rails for extended headroom and definition

Super responsive

Compact, rugged design

Selectable true bypass or buffered bypass modes

Related Questions and Answers

Q: 1. Is the modeling light proportional?

A: No, the modeling lamp on the Impact 180Ws Monolight is not proportional.

Q: 2. Does it have a polarity switch?

A: No

Q: 3. I recently purchased this kit and the fixture doesn't seem to seat correctly onto the light stand stud. Is there any special adapter needed for this kit out of the box? It seems as though the hole on the fixture is too shallow, so when I start to tighten the locking nut, the fixture tilts about 20 degrees. I can get it to safely fit snugly, it's just at a weird angle making top down light difficult. Any advise/ suggestions are greatly appreciated. Thanks. -Novice To Lights

A: Hi, the fixture pushes about 1 1/2 inches into the light stand stud. The bottom of the neck of the fixture should be touching the bottom of the stud ( the silver shiny part ) then tighten it with the locking nut. It should not tilt whatsoever. Make sure it's all the way in before you tighten the fixture. Otherwise you may have either a defective stand or light fixture. Hope this helps!

Q: 4. Do I need a particular microphone for boss vocoder vo-1?

A: This will work with any dynaminc microphone with an XLR connector.

Q: 5. How does it synch to a camera? Will it synch to other flashes such as Yongnuo?

A: This has a 3.5mm sync port and can be attached to a cable or a radio trigger.

Q: 6. Will this work in my smoke detector at home that accepts 9V batteries?

A: Yes it will , I would test the smoke detector every so often

Q: 7. if you overdub something, how do you get the audio file out of the looper to use somewhere else?

A: Thank you for your question. The only way to remove a loop is to plug the audio output of this pedal and record it on to an external audio recorder or into a computer with an audio interface.

Q: 8. What is the weight of the pedal,I fly with four,and must limit the weight?

A: The weight of the FV50H is 0.9 lb (0.4 kg).

Q: 9. Is this strictly 110v only or can this be used in Europe as well (220v)?

A: The Impact 180Ws Monolight Starter Flash listed above is designed for use on 110 VAC / 60 Hz AC power outlets. It is not designed for use on 220/240V AC power outlets and is not a multi-voltage light fixture. If you are looking for a multi-voltage monolight, the Raya SDR-400 Alpha Monolight, B&H # RASDR400, or the Jinbei DM-3 300Ws Portable Studio Monolight, B&H # JI101011306, would be compatible for use on 220/240V AC power outlets.

Q: 10. Is EV 5 compatible with Studiologic VMK 88 ?

A: The EV5 expression pedal is compatible with the StudioLogic SL88 Grand - 88 Key MIDI Controller with Graded Hammer Action, BH #STSL88GRAND.