The medium khaki Safari Photo Vest from CampCo is a 100% cotton vest that has 21 pockets, ranging in size from pen sized to oversized. The vented back and mesh liner allow free movement of air around the body. The snap epaulets will keep the camera, binoculars, or tote bag straps on the shoulder. The vest has a heavy-duty zipper that will close the entire front. It also has a single snap closure for the front and two snap adjustments for the sides. The vest is built oversized to accommodate fully filled pockets.

The Safari vest has a large pocket at the bottom back with two snaps; inside there is a large lined pocket that will keep sweat or rain from dampening papers. There are slash pockets on either side of the vest. On the right side from the top down, a shirt sized, bellows pocket with "hook & loop" fastening with two 'D' rings and a vertical zipper pocket with water resistant lining. A set of three pockets, one over the other with the smallest being net is closed with a "hook & clamp" loop, suitable for film or batteries, filters, lenses etc.

100% Cotton Shell and Lining    Webbed Back    21 Pockets

100% cotton vest with a vented back and mesh liner allows free movement of air around the body

Snap epaulets will keep the camera, binoculars, or tote bag straps on the shoulder

Zipper that will close the entire front

Single snap closure for the front and two snap adjustments for the sides

• 21 assorted pockets
• One large pocket at the bottom back with two snaps
• Inside there is one large lined pocket
• One huge flat buttoned pocket on the back of the vest
• Two slash pockets on the sides
• One shirt sized bellows pocket with two 'D' rings
• One vertical outside zipper pocket with water resistant lining
• Three pockets, one over the other with the smallest being made of net
• One large, lined zipper pocket behind two deep narrow bellows pockets
• One zipper pocket with a ring and snap for keys.
• One large, deep pocket with elastic at the top
• One slanted lined zipper pocket with a place for pen or small flashlight
• One large, deep, open pocket
• One lined pocket with three places for pens or small flashlights

Related Questions and Answers

Q: 1. In reference to the springs, the spec description states Blue Tension: 2.2-11 lb and red Tension: 11-22 lb. BUT not the product overview description is opposite as blue 11-22 lb and Red as 2.2 -22 lb. Which is it?

A: Our web team has corrected the mistake. our apologies for the confusion.

Q: 2. Would this unit work with a Sony FDR AX700 4K video camera?

A: Yes. The minimum weight capacity for this device is 1.75lb and this camera comes in at just a hair above 2lb.

Q: 3. Works with a Nikon D3400?

A: You would be able to use the stabilizer with the Nikon D3400.

Q: 4. Will this unit work with a Cannon 70D along with a zoom lens of 18-400mm attached?

A: A Canon 70D with the 18-400mm is about 4-5 lbs. The FLYCAM Galaxy Arm and Vest Kit with Redking Camera Stabilizer and its Camera Stabilizer, 7.5 lb Maximum Load will have no trouble handling the payload.

Q: 5. Are the makers of Flycam Redking or anyone else going to make a tripod head as an accessory for the flycam to be used interchangeable with a tripod using the same tripod plate? That appears to be a given. It would sure make the Flycam more versatile, provided it was a good tripod head.

A: That is not a question we can answer, however, we can give you their contact info so that you can express your feedback directly to them! FLYCAM Email sales@proaim.ca

Q: 6. Will the Flycam work with a lightweight camera like my Panasonic Lumix DMC-LX100 camera? It weighs 1 lb.

A: Yes, the following unit will accommodate any unit up to a15 lb payload.

Q: 7. Would I be able to hook a gimbal on this so I could film with my iPhone?

A: Yes, a motorized gimbal for an iphone would work on this vest harness.

Q: 8. Since this did not come with a bag or case, does anyone know of a good option to safely store and transport this?

A: This PKG tote bag would be a good fit for the Glide Gear SNC100 Snorricam DSLR Vest Harness: https://bhpho.to/3LkRjOu

Q: 9. Is this flycam made only for use with DSLRs or do you guys think I would have success using a glide cam like this Redking with a Canon XA11 video camera? The XA11 already has pretty good stabilization but I want really smooth hand held shots.

A: This has 7.5 lb load capacity. It should work well with the Canon XA11.

Q: 10. Will the Glidecam X-10 Support Arm Stabilizer support 25 lbs?

A: The Glidecam X10 is designed to be used with specific Glidecam Stabilizers. The option with the largest load capacity is the HD4000, which can handle up to 10 pounds and weighs around 3 pounds itself. The X-10 is really designed to handle no more than that combined weight of around 13 pounds. It will not support 25 pounds. Feel free to email us at provideo@bhphoto.com so we can help you find the appropriate Arm and Vest Kit for your needs.