The black Electro-Voice US602FL is a handheld noise-cancelling communications microphone designed for commercial installation, public address, and paging applications in a variety of indoor and outdoor environments. Its dynamic element requires no power source, and delivers an optimized-for-speech frequency response of 200 Hz to 5 kHz. The bidirectional polar pattern provides reduced pickup at off-axis points, especially at high frequencies.

A large push-to-talk button is featured for easy operation. The four-conductor, two shielded, coiled cable utilizes a rubber jacket and extends to a length of six feet. Made of high-impact polycarbonate, the housing ensures durability under stress. A panel mounting bracket is included for simple attachment to a convenient surface.

Dynamic Microphone Element    Bidirectional Polar Pattern    Noise-Cancelling Design    200 Hz to 5 kHz    Integral Push-to-Talk Switch    4-Conductor, 2 Shielded Cable    Coiled Cable Extends to 6'    Durable Polycarbonate Housing    Includes Panel Mounting Bracket

Bidirectional polar pattern provides reduced pickup at off-axis points, especially at high frequencies

200 Hz to 5 kHz frequency response and noise-cancelling design for articulate speech transmission in conditions with high levels of ambient noise

For use in public address, amateur radio, police, marine services, commercial applications, and paging

High output level

Stable performance during wide extremes of temperature and humidity

Large push-to-talk button opens the microphone's signal path

Rubber-jacketed coiled cable extends to 6'

Balanced circuit (with respect to ground)

Sturdy polycarbonate housing with black textured finish

Related Questions and Answers

Q: 1. Does it work with Fuji X-T3?

A: Yes it should. The AirCross 2 has a load capacity between 0.66 to 7.05 pounds and is designed to work with Mirrorless cameras like the Fuji X-T3.

Q: 2. Is it be possible to trigger stop/start recording on blackmagic pocket 4k through the gimbal?

A: Not that we are aware of. While you will be able to balance and shoot with a Pocket Cinema Camera 4K there will not be any control available over the camera from the gimbal.

Q: 3. would this gimbal fit the nikon coolpix p1000?

A: Yes, there are no foreseeable issues with this camera/gimbal combination.

Q: 4. Some YouTube reviewers said that unless you had very small mirrorless bodies and lenses, that the gimbal would shake slightly, even if we’ll below the recommended weight. They recommended the air 2 unless using crop/micro 4/3 and very light lenses. I plan to normally use a Nikon z6 and 14-30 f/4 lens. Some reviews said a similar weight set up put the gimbal motors occasionally at the 100% limit. Would prefer the smaller weight of the aircross with 3 axis locks and use with the slypod but want to make sure I’m not overloading it or getting minor shakes

A: based on the information you've provided it sounds like you would be over loading this gimbal and I would advise looking into a larger gimbal as your set up would be pushing the limits of this device and ti will not function as it was designed to under the conditions you have described

Q: 5. Does it work with Sony FDR AX100?

A: This gimbal stabilizer is designed for use with Mirrorless/DSLR Cameras up to 7 lb. It may not balance properly with camcorders at all.

Q: 6. Can this be purchased without Bluetooth and WiFi?

A: That is not possible.

Q: 7. Compatible with Panasonic lumix G9?

A: While the G9 is not on Zhiyun Tech's list as compatible for control with the gimbal, you will be able to balance and shoot with that camera on this gimbal.

Q: 8. Will it work with a Nikon d7500?

A: These products are compatible: This gimbal is for Mirrorless/DSLR Cameras up to 7 lbs. Nikon D7500: Weight: 1.41 lb / 640 g (Body Only)

Q: 9. Did it work with Canon 70 D?

A: Yes, this works with the Canon 70D.

Q: 10. So it is 5.5 pounds (2.5 kg) or 3.2 of as it is states on the official website?

A: The payload range is 0.3kg~3.2kg.