The cocoa E6 Directional Earset Mic, Medium Gain, with Detachable 2mm Cable and Hirose 4-Pin Connector for Sony Wireless Transmitters from Countryman is a vocal microphone with an adjustable boom that weighs less than one-tenth ounce. It can be used on either ear for capturing audio and rejecting unwanted sound, feedback, or surrounding noise from stage monitors or nearby speakers in houses of worship, theater, and outdoor vocal and speech applications.

The low-profile, directional E6 Earset virtually disappears against the skin, so performers forget they're wearing a mic. Three sensitivity options cover general speaking to extremely powerful vocals and four color options allow you to match the E6 to your skin tone for minimum visibility.

In addition, the E6 Earset features a pattern-changeable directional microphone for maximum isolation and gain before feedback, but is available as a water- and wind-resistant omnidirectional microphone too. This directional E6 Earset's cable terminates to a Hirose 4-pin connector for direct connection to a Sony WRT-8B, WRT-420, or WRT-822B wireless bodypack transmitter.

For Vocals and General Speaking    Detachable 2mm Cable    Hirose 4-Pin (SY), See Description    30 Hz to 15 kHz Frequency Response    Includes Cardioid & Hypercardioid Caps    Headroom for Strong Vocals    Windscreen    Cable Clips    Carrying Case

The Countryman E6 head-worn Earset is small and lightweight, and is hardly visible from a distance.

The E6 Earset's stainless steel boom is built tough and can be bent and re-bent many times to fit different performers. The E6 is highly resistant to makeup, sweat, and moisture when used with the supplied protective caps.

The flexible boom is easily shaped right on the performer's face and is available in multiple skin tones. Their protective caps let you shape the frequency response for different situations or to match other microphones; caps for the directional earset adjust the pattern from cardioid to hypercardioid. Choose a sensitivity for speaking or singing with up to 145 dB SPL capability.

The E6 provides high-quality audio with low distortion and an SPL of up to 145 dB. It delivers rich, full band audio quality.

Easy adjustment keeps the mic in a position for rejecting unwanted sounds. Countryman's omnidirectional Earset offers a reduction of 12 dB compared to a lavalier mic, while the directional E6 Earset provides even more isolation. Excellent for houses of worship, theater, and outdoor events.

An E6 replacement cable installs in seconds. The snap-on cables are rugged and available for almost any wireless transmitter or for XLR inputs with phantom power.

For speaking and vocals.

Related Questions and Answers

Q: 1. Can I use the X1N trigger as Commander to 2 SB-900s & an SB-500? Or would I have to trigger one of them to trigger the other 2? But then that would be a manual setting for each?

A: When I shot with Nikons, I had several SB900's. It is my understanding that they are optically triggered. The sensor is on the right side of the unit viewed from the back. The x1N is a RF unit. It does not have an optical output. If you wanted to operate the SB's, there is a receiver that can accomodate the SB's and that would allow the X1N to operate them. The real advantage to doing that would be the operating distance goes out to about 300 feet. So, putting the flash behind the subject would work well, when using the optical trigger would be difficult. Hope this helps.

Q: 2. Will this work on my Panasonic LX7 camera? The LX7 has HSS up to 1/4000 sec.

A: I use it on Olympus cameras. There is no reason it should not work on your LX7.

Q: 3. If I mount a Yongnuo flash on top of a Godox receiver will the Godox transmitter fire the Yongnuo flash?

A: I have mounted a promaster flash it works fine. It has a Sony shoe and the ttl worked fine also.

Q: 4. Can I use the godox x1t sony trigger on Sony camera to trigger my canon flash on the godox receiver for canon flashes?

A: While you can use the Godox X1T-S transmitter on your Sony camera to trigger a Canon flash with a Godox X1R-C receiver, you would be limited to manual mode only.

Q: 5. Will this system work on SB 800 set on manual exposure? Or does it have to be set on TTL?

A: The SB-800 can be used in both TTL and manual when using this Godox trigger.

Q: 6. Will this trigger a Godox V860IIF ?

A: While off camera the Godox V860 will accept a signal from any of the Godox X1 or XPro transmitters. You Can TTL HSS and adjust power just like it was native. Its only when a Godox flash is on the camera shoe that the brand version matters.

Q: 7. Having my Canon 580EX connected to the receiver, Can I set to manual from the transmitter, AND make Power adjustments (1/1, 1/16 ... 1/128) as well? (I saw the video and this is possible with other speed lights brand, but Canon? Thanks for a reply!

A: Yes you can control the mode and power level from the remote.

Q: 8. Can I trigger theX1N on an SB900 with the X2N trigger on my D500?

A: Yes

Q: 9. Will this trigger work with a godox flash for Sony used as a remote?

A: If you are using a Godox-branded flash designed for Sony cameras, if the Godox flash has the most recent firmware update, and you are using a Micro Four Thirds camera (either an Olympus or Panasonic M43 camera), then yes, the Godox X1T-O TTL Wireless Flash Trigger Transmitter for Olympus/Panasonic, B&H # GOX1TCOP, listed above mounted on your M43 camera would be able to wirelessly trigger your Godox-branded Sony flash as the most recent firmware update from Godox allows for cross-platform compatibility with their X-system flashes.

Q: 10. Do I need to buy two of these? One for camera and one for flash? Or do I just need one for the camera?

A: One for the camera , this is a trigger , if you have Godox flash you do not need a receiver if you are using other brand flash than you need this Godox X1R-S TTL Wireless Flash Trigger Receiver for Sony BH #GOX1RS