The cocoa E6 Omnidirectional Earset Mic, Highest Gain, with Detachable 2mm Cable and Hirose 6-Pin Connector for Samson Wireless Transmitters from Countryman is a vocal microphone with an adjustable boom that weighs less than one-tenth ounce. It is a water- and wind-resistant microphone that can be used on either ear for capturing audio in houses of worship, theater, or outdoor vocal and speech applications.

The low-profile, omnidirectional E6 Earset virtually disappears against the skin, so performers forget they're wearing a mic. Three sensitivity options cover general speaking to extremely powerful vocals and four color options allow you to match the E6 to your skin tone for minimum visibility.

In addition, the E6 Earset features three omni caps (very bright +8 dB, bright +4 dB, and flat +0 dB) that deliver response characteristics for most other applications such as recording flute and violin. The E6 Earset is available as a directional microphone too with cardioid and hypercardioid caps. This omnidirectional E6 Earset's cable terminates to a Hirose 6-pin connector for direct connection to a Samson TX3 (Black), UT5, or UT6 wireless bodypack transmitter.

For Vocals and General Speaking    Detachable 2mm Cable    Hirose 6-Pin (SX), See Description    20 Hz to 20 kHz Frequency Response    Headroom for Strong Vocals    Includes +8, +4, and +0 dB EQ Caps    Windscreen    Cable Clips    Carrying Case

The Countryman E6 head-worn Earset is small and lightweight, and is hardly visible from a distance.

The E6 Earset's stainless steel boom is built tough and can be bent and re-bent many times to fit different performers. The E6 is highly resistant to makeup, sweat, and moisture when used with the supplied protective caps.

The flexible boom is easily shaped right on the performer's face and is available in multiple skin tones. Their protective caps let you shape the frequency response for different situations or to match other microphones; caps for the directional earset adjust the pattern from cardioid to hypercardioid. Choose a sensitivity for speaking or singing with up to 140 dB SPL capability.

The E6 provides high-quality audio with low distortion and an SPL of up to 140 dB. It delivers rich, full band audio quality.

Easy adjustment keeps the mic in a position for rejecting unwanted sounds. Countryman's omnidirectional Earset offers a reduction of 12 dB compared to a lavalier mic, while the directional E6 Earset provides even more isolation. Excellent for houses of worship, theater, and outdoor events.

An E6 replacement cable installs in seconds. The snap-on cables are rugged and available for almost any wireless transmitter or for XLR inputs with phantom power.

For general speaking.

Related Questions and Answers

Q: 1. I just received a Godox TT685c and an XProC. The XProC is working with the Godox speedlite, but I was under the impression that the XProC would also fire my Canon 600EXRT. However now I'm thinking I need the X1R-C attached to the Canon Speedlite to make it work. Is this correct?

A: I dont use the Canon product, so I am unable to advise. Hal Baxley.

Q: 2. will the x1 trigger a godox TT600 in TTL mode?

A: No, The Godox X1R-N TTL Wireless Flash Receiver for Nikon is not recommended for using with TTL enabled flash units. The recommended trigger for the Godox TT600 Thinklite Flash is the Godox X2 2.4 GHz TTL Wireless Flash Trigger for Nikon.

Q: 3. Is this compatible with nikon d500?

A: YES! I have the D500 and this flash works well and integrates fully with the camera.

Q: 4. Can I trigger remotely a Nikon D500 with Nikon SB-800 on it and a two other nikon flashes with 1 trasmiter and 2 receivers ?

A: Yes

Q: 5. Will this trigger a camera?

A: Yes it can for compatible cameras.

Q: 6. will it be absolutely compatible with nissin i40, TTL HSS?

A: Unfortunately, Nissin does not produce an Air R Receiver for the i40 with the Micro 4/3 interface at this time. That being said, this transmitter cannot trigger the flash wirelessly in TTL or HSS.

Q: 7. Can I use the x1r-n to trigger a D300 using a hand held xpro-n? If so do you know what cable I would need?

A: The Godox system is awesome. There is another trigger R2 FlashPoint if you want to do High Speed Sync. Don't leave hone with out it... If you are using Godox SB's with a Godox master on the camera you will not require it, however if you are just managing groups is worth it.

Q: 8. Will this controller work with YN622 cII transeivers?

A: The YN685 flash comes with builtin Transceiver that works with YN622 model, you dont need an additional transceiver

Q: 9. Is this compatible with the the new canon 1D Xmii

A: hi Ken but I heard that yn 685 has inbuilt receivers. so why need 2 yn622c.

Q: 10. Can these be triggered with the XProN (Nikon) trigger? I want to use Yongnuo flashes (that are compatible with Nikon cameras) in these receivers and trigger them with the XProN trigger I have for my camera (from Godox).

A: Yes, the XproN will trigger this receiver.