The black Countryman E6 Omnidirectional Earset Mic, Standard Gain with Detachable 2mm Cable and TA4F Connector for Anchor Audio Wireless Transmitters is a vocal microphone with an adjustable boom that weighs less than one tenth of an ounce and is designed to be used by only one person. Once adjusted, it will continually hold this shape.

The E6 earset can be used on either ear for capturing audio and rejecting unwanted sound, feedback, or surrounding noise from stage monitors or nearby speakers in houses of worship, theater, and outdoor vocal and speech applications.

The low-profile, omnidirectional E6 earset virtually disappears against the skin, so performers will forget they're wearing a mic. This version offers the highest gain for general speaking such as presentations or sermons. In addition, the earset comes with three protective caps with different high-frequency response characteristics that control the amount of crispness or sibilance (response at 15 kHz). This omnidirectional E6 earset's cable terminates to a TA4F connector for direct connection to Anchor Audio WB-6000, WB-6400, and WB-8000 wireless bodypack transmitters.

For Stage, Theater, and Broadcast TV    Fits Anchor Audio Transmitters    Headroom for General Speaking    Detachable 2mm Diameter Cable    Stiff, Steel Boom    Includes Windscreen    3 x Protective Caps    Black and White Single Tie Cable Clips    Carrying Case

The Countryman earsets are very small, lightweight, and the least visible headworn microphones.

The classic E6 is a good choice when one person will wear the microphone. Because the boom is stiffer, it can be adjusted to fit, then stored away and quickly reworn.

The E6's stainless steel boom is tough and can be bent and re-bent to fit different performers. It is highly resistant to makeup, sweat, and moisture when used with the supplied protective caps. The earset should always have a protective cap in place to keep sweat, makeup, and other foreign material out of the microphone.

The E6 earset's flexible boom is easily shaped right on the performer's face. Changeable protective caps let you shape the frequency response for different situations or to match other microphones. This omnidirectional version includes three protective caps—+4 dB (bright), +8 dB (very bright) and +0 dB (flat)—that controls the amount of crispness or sibilance (response at 15 kHz.)

Easy adjustment keeps the mic in a comfortable position for rejecting unwanted sounds. The omnidirectional E6 earset provides more isolation and is suitable for situations where there are loud monitors, extreme feedback, or environmental noise.

The included removable, quick-swap cable detaches from the actual earset, making it completely replaceable in the event of a short or break. The replaceable cable design makes upgrading wireless microphone systems easy as they are available in a wide selection of connections to accommodate most wireless transmitters.

Related Questions and Answers

Q: 1. What do I need to connect a Nikon Z7 to an SB 5000 off camera?

A: This set would do

Q: 2. Is this compatible with RX1Rii? Will it obstruct the pop up VF?

A: Sorry, but I do not know. I do suggest you call the pros at B&H. They will know the answers and suggest alternatives if appropriate to best fulfill your needs.

Q: 3. Is this compatible with a HVL-F45RM flash? thank u

A: It is not directly compatible. You can use one of these receivers to make it work. https://bhpho.to/2Gh8EpU

Q: 4. Does it work with Nikon sb 700 and Nikon sb 5000 flashes?

A: The Nissin Air 10s commander can be used to wirelessly control Nissin NAS (Nissin Air System) compatible flashes, including the Nissin MG80 Pro, MG60, or MG10. The Air 10s can also be used with older Nissin NAS compatible flashes, including the Nissin Di700A and i60A. Nikon's flashes are not built to be NAS compatible, therefore the Air 10s Nikon cannot be used to control the Nikon SB700 or SB5000 flashes.

Q: 5. Does Nissin Air10 will work with Metz flash (64 Af1 and Metz 76Mz5?

A: The Nissin Air R Receiver for Nikon Flashes B&H # NINDARNIK is needed to fire the Metz 64AF1 attached to its shoe and the Metz 76MZ5 attached with a sync cable.

Q: 6. Will the Yongnuo YN685 Wireless TTL Speedlite for Nikon Cameras communicate with the Nikon wireless remote controller wr-r10?Thank you

A: The only speed light that can be controlled by the WR-R10 is the Nikon SB-5000.

Q: 7. Will Godox x1t-N work with elinchrom strobes and is it compatible with their high speed sync functionality?

A: HelloIm new to using wireless triggers, and dont know if this Godox will meet your need. Im sorry Im unable to help.

Q: 8. Can I put the transmitter on a Nikon z50 and fire a Nikon d500 with receiver attached?

A: If you have the Godox X1R-N TTL Wireless Flash Trigger Receiver for Nikon connected to the remote terminal on the Nikon D500 DSLR camera via the included N1 Camera Sync Cable, and you have the Godox X1T-N TTL Wireless Flash Trigger Transmitter for Nikon connected to the Nikon Z50 Mirrorless Digital Camera and both remotes are set to the same channel/group, then yes, triggering the Nikon Z50 should also wirelessly trigger the Nikon D500.

Q: 9. I have Sony A7riii with a Sony flash F45rm. can I get all the funtions of my flash using the Godox pros, and do I need the receiver?

A: You can get Sony FA-WRC1M Wireless Radio Commander B&H # SOFAWRC1M and use its built in radio or you can purchase Godox XProS Godox XProS TTL Wireless Flash Trigger for Sony Cameras BH #GOXPROS they both would work just with Sony you would have less items to connect

Q: 10. Will this work with my Nikon D3500?

A: This Godox Nikon Receiver will work on a Nikon Flash if you have another unit - either a Godox Nikon flash with radio built in or the Godox X1T-N TTL Wireless Flash Trigger Transmitter for Nikon B&H # GOX1TN on the camera.