The cocoa Countryman E6 Omnidirectional Earset Mic, Standard Gain with Detachable 2mm Cable and 4-Pin Hirose Connector for Azden Wireless Transmitters is a vocal microphone with an adjustable boom that weighs less than one tenth of an ounce and is designed to be used by only one person. Once adjusted, it will continually hold this shape.

The E6 earset can be used on either ear for capturing audio and rejecting unwanted sound, feedback, or surrounding noise from stage monitors or nearby speakers in houses of worship, theater, and outdoor vocal and speech applications.

The low-profile, omnidirectional E6 earset virtually disappears against the skin, so performers will forget they're wearing a mic. This version offers the highest gain for general speaking such as presentations or sermons. In addition, the earset comes with three protective caps with different high-frequency response characteristics that control the amount of crispness or sibilance (response at 15 kHz). This omnidirectional E6 earset's cable terminates to a 4-pin Hirose connector for direct connection to Azden UHF 41BT wireless bodypack transmitters.

For Stage, Theater, and Broadcast TV    Fits Azden Transmitters    Headroom for General Speaking    Detachable 2mm Diameter Cable    Stiff, Steel Boom    Includes Windscreen    3 x Protective Caps    Black and White Single Tie Cable Clips    Carrying Case

The Countryman earsets are very small, lightweight, and the least visible headworn microphones.

The classic E6 is a good choice when one person will wear the microphone. Because the boom is stiffer, it can be adjusted to fit, then stored away and quickly reworn.

The E6's stainless steel boom is tough and can be bent and re-bent to fit different performers. It is highly resistant to makeup, sweat, and moisture when used with the supplied protective caps. The earset should always have a protective cap in place to keep sweat, makeup, and other foreign material out of the microphone.

The E6 earset's flexible boom is easily shaped right on the performer's face. Changeable protective caps let you shape the frequency response for different situations or to match other microphones. This omnidirectional version includes three protective caps—+4 dB (bright), +8 dB (very bright) and +0 dB (flat)—that controls the amount of crispness or sibilance (response at 15 kHz.)

Easy adjustment keeps the mic in a comfortable position for rejecting unwanted sounds. The omnidirectional E6 earset provides more isolation and is suitable for situations where there are loud monitors, extreme feedback, or environmental noise.

The included removable, quick-swap cable detaches from the actual earset, making it completely replaceable in the event of a short or break. The replaceable cable design makes upgrading wireless microphone systems easy as they are available in a wide selection of connections to accommodate most wireless transmitters.

Related Questions and Answers

Q: 1. Can I use the X1N trigger as Commander to 2 SB-900s & an SB-500? Or would I have to trigger one of them to trigger the other 2? But then that would be a manual setting for each?

A: When I shot with Nikons, I had several SB900's. It is my understanding that they are optically triggered. The sensor is on the right side of the unit viewed from the back. The x1N is a RF unit. It does not have an optical output. If you wanted to operate the SB's, there is a receiver that can accomodate the SB's and that would allow the X1N to operate them. The real advantage to doing that would be the operating distance goes out to about 300 feet. So, putting the flash behind the subject would work well, when using the optical trigger would be difficult. Hope this helps.

Q: 2. Hi fellas, I have a Godox AD400Pro, the Xpro C transmitter & two Canon 600EXII-RT, and I'm trying to find out if this works. T

A: Yes, the Godox X1R-C TTL Wireless Flash Trigger Receiver for Canon flashes will work with your Godox ad400 and will become part of the echo system and react as one.

Q: 3. Is this printer capable of manual duplexing?

A: Of course, just flip the paper over and reload it blank side up.

Q: 4. I have a Nikon D3300 and a Altura speedlite for nikon, will this Gordox Trigger & Receiver set work in TTL mode, or must I set my flash power level independently?

A: While this Godox trigger system can trigger Nikon compatible flashes in TTL mode, it has not been tested with the Altura Speedlights for Nikon, therefore we cannot account for their compatibility. Your results may vary.

Q: 5. Can I use this with one on camera flash and 2 off camera flashes? Would I need 1 transmitter and 2 receivers? Nikon D850 and 3 SB-700s

A: You will need a transmitter for the camera and one receiver per off camera flash.

Q: 6. Does it work with the Canon Rebel t7i?

A: Yes, this trigger set is compatible with the Canon Rebel T7i.

Q: 7. If I have a Godex flash can I just buy the transmitter or do i need the receiver too or is the receiver function built into the Godex 600 flash?

A: QS, QT and AD series 600 flashes have the receiver built in.

Q: 8. My understanding is that the transmitter can’t force the SB700 to fire at anything higher more powerful than 1/4, is this correct?

A: This transmitter will not work with the SB700

Q: 9. Hi,I want to ask if it is possible to use YN-685 on-camera to fire Nikon flash set on the YN-622N trigger (eg. on the light stand) so they fire simultaneously? Is that possible please?Thank youMario

A: Unfortunately, no, the setup you describe above would not work as you describe. The YN685 for Nikon does not directly provide any radio master functions as it only has a built-in radio receiver, not a transmitter or transceiver. As such, it may only be used wirelessly off-camera for radio triggering usage needs when a YN-622N-TX, YN-622N / II, YN560-TX, YN560IV, YN660 RF-605, or RF-603 II transmitters are used on the camera as a master transmitter. You may either connect an additional YN-622N transceiver on the camera's hot shoe (with the YN-685 on top of the unit) for your usage needs, or use one of the Nikon flashes on the YN-622N on the camera's hot shoe, and use the built-in radio in the YN-685 for use as your off-camera flash.

Q: 10. Will a pocket wizards work on top of this to fire other lights from another lighting system?

A: You could use a Pocketwizard on top of this, but in most cases it would be easier to just get a Godox receiver for the light.