The cocoa E6 Directional Earset Mic, Highest Gain, with Detachable 1mm Cable and Hirose 4-Pin Connector for Audio-Technica Wireless Transmitters from Countryman is a vocal microphone with an adjustable boom that weighs less than one-tenth ounce. It can be used on either ear for capturing audio and rejecting unwanted sound, feedback, or surrounding noise from stage monitors or nearby speakers in houses of worship, theater, and outdoor vocal and speech applications.

The low-profile, directional E6 Earset virtually disappears against the skin, so performers forget they're wearing a mic. Three sensitivity options cover general speaking to extremely powerful vocals and four color options allow you to match the E6 to your skin tone for minimum visibility.

In addition, the E6 Earset features a pattern-changeable directional microphone for maximum isolation and gain before feedback, but is available as a water- and wind-resistant omnidirectional microphone too. This directional E6 Earset's cable terminates to a Hirose 4-pin connector for direct connection to an Audio-Technica ATW-T1801, ATW-T27, ATW-T31, ATW-T51, ATW-T201, ATW-T210, ATW-T210a, ATW-T310, or ATW-T310b wireless bodypack transmitter for use with 200 Series, 1100 Series, 1400 Series, 1800 Series, 2000 Series, 2000A Series, 3000 Series, or 3000A Series wireless systems.

For Vocals and General Speaking    Detachable 1mm Cable    Hirose 4-Pin (AT), See Description    30 Hz to 15 kHz Frequency Response    Includes Cardioid & Hypercardioid Caps    Headroom for Strong Vocals    Windscreen    Cable Clips    Carrying Case

The Countryman E6 head-worn Earset is small and lightweight, and is hardly visible from a distance.

The E6 Earset's stainless steel boom is built tough and can be bent and re-bent many times to fit different performers. The E6 is highly resistant to makeup, sweat, and moisture when used with the supplied protective caps.

The flexible boom is easily shaped right on the performer's face and is available in multiple skin tones. Their protective caps let you shape the frequency response for different situations or to match other microphones; caps for the directional earset adjust the pattern from cardioid to hypercardioid. Choose a sensitivity for speaking or singing with up to 145 dB SPL capability.

The E6 provides high-quality audio with low distortion and an SPL of up to 145 dB. It delivers rich, full band audio quality.

Easy adjustment keeps the mic in a position for rejecting unwanted sounds. Countryman's omnidirectional Earset offers a reduction of 12 dB compared to a lavalier mic, while the directional E6 Earset provides even more isolation. Excellent for houses of worship, theater, and outdoor events.

An E6 replacement cable installs in seconds. The snap-on cables are rugged and available for almost any wireless transmitter or for XLR inputs with phantom power.

For general speaking.

Related Questions and Answers

Q: 1. With XProC on camera and 580 Speedlight on XR1-c, can I access Flash settings via camera External Flash Setting settings?

A: Yes, the Godox X1R-C TTL Wireless Flash Receiver for Canon with the 580 flash can be controlled using he Godox XProC.

Q: 2. Can the x1n Transmitter be used on a d750 with a Nikon sb700 and a Godox Ad200 keeping TTL?

A: The X1T-N will work on a D750 with an AD200 full TTL, HSS and manual adjustments. In order to have it work with an SB you will need a receiver for the flash https://bhpho.to/2Xj9N7M.

Q: 3. What is the max sync speed? I need 1/250sec

A: Because your camera uses TTL, this will duplicate just as if your speed light is on camera. I have noticed that when this set up is used, it automatically switched my camera to Manuel flash. You're going to control your speedlight output using the controls on the transmitter. Really nice set up without spending Pocket Wizard money.

Q: 4. I am migrating from a Nikon DSLR to Fuji X-T3, but would like to keep using my two SB-600 strobes (presently hooked up via a Yongnuo N system). Will two of the X1R-N, controlled from an XPro-F on the camera, do the job?

A: You can trigger your Nikon SB-600 flashes with X1R-N receivers on each from the Godox X-Pro F transmitter, but TTL is not guaranteed.

Q: 5. Is this compatible with Godox FT-16?

A: No. The X system is 2.4GHz, the F system is 433MHz. Godox has created XT16 replacement triggers for the lights that can use FT16 receivers: XTR16 and XTR16s. These let you use an AD180, AD360, V850, or V860 with the X1T transmitters.

Q: 6. will the odox X1T-F TTL Wireless Flash Trigger Transmitter for Fujifilm work on the XPro1 ?

A: Yes, the Fujifilm X-Pro1 is listed as compatible for use with the Godox X1T-F TTL Wireless Flash Trigger Transmitter for Fujifilm, B&H # GOX1TF. However, do note that on Godox's webpage, they state Fuji cameras are divided into three kinds according to their different ways to control flash. The X-Pro1 is in their B category, and it will be compatible with Standard TTL and Manual flash, as well as standard Stroboscopic Flash capabilities when using the X1T-F wireless trigger. It will not have rear-curtain sync or High-Speed Sync (Focal Plane Sync) capabilities, and the AF-Assist Beam will not illuminate when using the X-Pro1 (or X-T10, X-E1, or X-A3 cameras, all which have similar performance as the X-Pro1 with the Godox X1T-F TTL Wireless Flash Trigger Transmitter for Fujifilm).

Q: 7. Can I sync this unit with Profoto D1? I already have Godox XProC TTL wireless flash trigger. Thank you

A: No.

Q: 8. Will it handle transparency sheets? Can I print wirelessly from my computer?

A: I only use this printer wirelessly from three different computers. A Compaq, a Lenovo, and the afore mentioned iPad mini. Yes it is large, maximum print width is 13 inches. There has to be room for the print carriage to clear the paper at both ends. If you want large prints it takes a large printer.

Q: 9. How do I know if the Air10 is communicating with my SONY A9? the test pilot will trigger i60a flash but won't fire when shutter release...

A: The Flash Mode in the Camera Settings 1 would need to be set for Wireless (WL) in order to use the Air 10 Transmitter properly on the Sony A9.

Q: 10. Can this be used to trigger a camera?

A: Yes it can.