The cocoa Countryman E6 Omnidirectional Earset Mic, Standard Gain with Detachable 1mm Cable and LEMO 6-Pin Connector for Micron Wireless Transmitters is a vocal microphone with an adjustable boom that weighs less than one tenth of an ounce and is designed to be used by only one person. Once adjusted, it will continually hold this shape.

The E6 earset can be used on either ear for capturing audio and rejecting unwanted sound, feedback, or surrounding noise from stage monitors or nearby speakers in houses of worship, theater, and outdoor vocal and speech applications.

The low-profile, omnidirectional E6 earset virtually disappears against the skin, so performers will forget they're wearing a mic. This version offers the highest gain for general speaking such as presentations or sermons. In addition, the earset comes with three protective caps with different high-frequency response characteristics that control the amount of crispness or sibilance (response at 15 kHz). This omnidirectional E6 earset's cable terminates to a LEMO 6-pin connector for direct connection to Micron TX 700-Series wireless bodypack transmitters.

For Stage, Theater, and Broadcast TV    Fits Micron Transmitters    Headroom for General Speaking    Detachable 1mm Diameter Cable    Stiff, Steel Boom    Includes Windscreen    3 x Protective Caps    Black and White Single Tie Cable Clips    Carrying Case

The Countryman earsets are very small, lightweight, and the least visible headworn microphones.

The classic E6 is a good choice when one person will wear the microphone. Because the boom is stiffer, it can be adjusted to fit, then stored away and quickly reworn.

The E6's stainless steel boom is tough and can be bent and re-bent to fit different performers. It is highly resistant to makeup, sweat, and moisture when used with the supplied protective caps. The earset should always have a protective cap in place to keep sweat, makeup, and other foreign material out of the microphone.

The E6 earset's flexible boom is easily shaped right on the performer's face. Changeable protective caps let you shape the frequency response for different situations or to match other microphones. This omnidirectional version includes three protective caps—+4 dB (bright), +8 dB (very bright) and +0 dB (flat)—that controls the amount of crispness or sibilance (response at 15 kHz.)

Easy adjustment keeps the mic in a comfortable position for rejecting unwanted sounds. The omnidirectional E6 earset provides more isolation and is suitable for situations where there are loud monitors, extreme feedback, or environmental noise.

The included removable, quick-swap cable detaches from the actual earset, making it completely replaceable in the event of a short or break. The replaceable cable design makes upgrading wireless microphone systems easy as they are available in a wide selection of connections to accommodate most wireless transmitters.

Related Questions and Answers

Q: 1. Will this work with the Canon 1200D Rebel T5 Camera?

A: Yes, the Godox XPro C can work on the Canon 1200D/Rebel T5 camera.

Q: 2. Will the Godox Xpro ll flash trigger work with the Nikon Z9?

A: Yes, the Godox XProN TTL Wireless Flash Trigger for Nikon Cameras works with the Nikon Z9.

Q: 3. Does it work in TTL mode (including A:B) with Nikon Z8 and Godox TT685N flashes?

A: Yes, the commander will adapt to all 3 protocol systems for the Nikon Z8 that being control modes Manual, TTL, i-TTL.

Q: 4. I understand this Sony trigger will work on my Sony A1 to trigger Nikon flashes using the Godox Nikon receivers. Correct? What are the limitations? I assume it will only trigger and I will have to set power, etc manually at each flash. Correct?

A: As long as the Godox XProS TTL Wireless Flash Trigger for Sony Cameras is mounted onto a Sony camera with a Multi-Interface hot shoe, it can communicate with other Godox-branded flashes and wireless radio receivers as long as they are X-wireless compatible and they have been updated with the most recent firmware. If the Godox receivers you use with your Nikon flashes have the most recent firmware, the Godox XProS TTL Wireless Flash Trigger for Sony Cameras will wirelessly trigger your Nikon flashes, and you should be able to use both TTL or manual power settings.

Q: 5. My set up is a Nikon Z9 and a SB-5000 flash. I use the WR-R10/WR-T10/WR-A10 Wireless Remote for off camera flash, but want to control the flash power remotely as well. The Nikon WR-1 is $625, while this Godox is only $69. Will this work with my set up? Thanks.

A: No, the Godox XProN TTL Wireless Flash Trigger for Nikon Cameras is only for Godox brand flashes that support it.

Q: 6. Is There a updated one for the canon r3 I think it would be xproc II but can not find it Thank you

A: At t his time there is only the version one, Godox XProC TTL Wireless Flash Trigger for Canon Cameras. The Version two that are out now is for Leica.

Q: 7. I'm using the X Pro C with my R5 to trigger several off-camera Godox strobes/flashes. My experience is that all strobes must be on the same Channel (e.g., Channel 1). If I assign some to Channel 1 and others to Channel 2, I cannot fire both channels simultaneously. Only the channel that is active on the trigger fires. Am I missing something or is it not possible to fire multiple channel simultaneously? Thanks.

A: Only the channel that is selected on the transmitter can fire those strobes. channel 1 on transmitter will fire only those lights on channel. You can use different to turn light on and off.

Q: 8. Will this work on a Nikon FM10 film camera to trigger V860IIF speedlites? (Fuji Version)

A: The Godox XProN TTL Wireless Flash Trigger for Nikon Cameras should work on the Nikon FM10 to set off the Godox V860IIF. You will need to set in the menu of the trigger to use the center pin only. And the flash will be manual only. It will not support TTL or HSS.

Q: 9. will this work on the canon r3?

A: it has not been tested but technically the Godox XProC TTL Wireless Flash Trigger for Canon Cameras will work on the Canon R3. But you will need the Canon AD-E1 Multi-Function Shoe Adapter, https://bhpho.to/3sqLfdx .

Q: 10. Will this work with Nikon Z7 and SB 700 speedlight?

A: The Godox X1R-N TTL Wireless Flash Trigger Receiver for Nikon can be attached to the SB-700 so you can trigger it from the XPro N Trigger mounted on your Nikon Z7.