The tan Countryman E6 Omnidirectional Earset Mic, Standard Gain with Detachable 2mm Cable and LEMO 4-Pin Connector for Vega Wireless Transmitters is a vocal microphone with an adjustable boom that weighs less than one tenth of an ounce and is designed to be used by only one person. Once adjusted, it will continually hold this shape.

The E6 earset can be used on either ear for capturing audio and rejecting unwanted sound, feedback, or surrounding noise from stage monitors or nearby speakers in houses of worship, theater, and outdoor vocal and speech applications.

The low-profile, omnidirectional E6 earset virtually disappears against the skin, so performers will forget they're wearing a mic. This version offers the highest gain for general speaking such as presentations or sermons. In addition, the earset comes with three protective caps with different high-frequency response characteristics that control the amount of crispness or sibilance (response at 15 kHz). This omnidirectional E6 earset's cable terminates to a LEMO 4-pin connector for direct connection to Vega 77 and 677 wireless bodypack transmitters.

For Stage, Theater, and Broadcast TV    Fits Vega Transmitters    Headroom for General Speaking    Detachable 2mm Diameter Cable    Stiff, Steel Boom    Includes Windscreen    3 x Protective Caps    Black and White Single Tie Cable Clips    Carrying Case

The Countryman earsets are very small, lightweight, and the least visible headworn microphones.

The classic E6 is a good choice when one person will wear the microphone. Because the boom is stiffer, it can be adjusted to fit, then stored away and quickly reworn.

The E6's stainless steel boom is tough and can be bent and re-bent to fit different performers. It is highly resistant to makeup, sweat, and moisture when used with the supplied protective caps. The earset should always have a protective cap in place to keep sweat, makeup, and other foreign material out of the microphone.

The E6 earset's flexible boom is easily shaped right on the performer's face. Changeable protective caps let you shape the frequency response for different situations or to match other microphones. This omnidirectional version includes three protective caps—+4 dB (bright), +8 dB (very bright) and +0 dB (flat)—that controls the amount of crispness or sibilance (response at 15 kHz.)

Easy adjustment keeps the mic in a comfortable position for rejecting unwanted sounds. The omnidirectional E6 earset provides more isolation and is suitable for situations where there are loud monitors, extreme feedback, or environmental noise.

The included removable, quick-swap cable detaches from the actual earset, making it completely replaceable in the event of a short or break. The replaceable cable design makes upgrading wireless microphone systems easy as they are available in a wide selection of connections to accommodate most wireless transmitters.

Related Questions and Answers

Q: 1. Hi, I'd like to know if the XPro-P is compatible with a 645D camera and a Witstro AD-180 flash (with the XTR16 receiver) ?

A: Yes. But the system will have to be used in all manual mode.

Q: 2. Ricoh Gr iii

A: Yes. The following unit will work there will be no TTL communication.

Q: 3. Will the Godox XProS TTL Wireless Flash Trigger for Sony Cameras work with the Sony RX-10 IV? And flash synch up to 1/2000?

A: According to all the specifications the Godox XProS TTL Wireless Flash Trigger for Sony Cameras should work with the Sony RX10 IV with a Godox flash in HSS up to 1/2000. It has not been tested by either company.

Q: 4. Will this also transmit in infrared to substitute as a commander to trigger a Metz ring flash. I just got a Nikon z6 and I'm trying to have one accessory work with both strobes and the wireless ring flash.

A: This is only a radio transmitter. It does not give off any optical transmission.

Q: 5. Whic h receiver do you need to use with a Pentax flash?

A: This transmitter can only trigger Godox flashes like the Godox V1, TT350P, and the AD series flashes. Unfortunately, they do not produce a Pentax compatible receiver separately to use on Pentax brand flashes.

Q: 6. Will this work with 860ii flashes?

A: Yes, the XPRO-S trigger will work with Godox flashes such as the VING V860II-S for Sony.

Q: 7. Will the Godox XPro work with Canon flashes? Such as the 580 EXII or the 600 EX/EX II

A: In order for the Godox XProC Trigger to fire the Canon 580EX II or the Canon 600EX RT/EX II RT flashes, you would need to attach a Godox X1R-C TTL Wireless Flash Trigger Receiver for Canon, BH # GOX1RC. https://bhpho.to/3kcLQ1h

Q: 8. Will this product work with a Canon 600EX II-RT?

A: One must use the additional receiver under Your flash to be compatable. Godox X1R-C TTL Wireless Flash Trigger Receiver for Canon B&H # GOX1RC MFR # X1R-C

Q: 9. will any external speed light battery compatible with canon work with this flash?

A: Being that this flash uses the same HV port as Canon speedlites, you could use an external battery pack as long as it offers a CZ type cable such as those from Quantum, Lumedyne or Bolt.

Q: 10. Will this work with a Godox Wistro AD360ii-C?

A: Yes it will work well