The black Countryman E6 Omnidirectional Earset Mic, Medium Gain with Detachable 2mm Cable and LEMO 6-Pin Connector for Micron Wireless Transmitters is a vocal microphone with an adjustable boom that weighs less than one tenth of an ounce and is designed to be used by only one person. Once adjusted, it will continually hold this shape.

The E6 earset can be used on either ear for capturing audio and rejecting unwanted sound, feedback, or surrounding noise from stage monitors or nearby speakers in houses of worship, theater, and outdoor vocal and speech applications.

The low-profile, omnidirectional E6 earset virtually disappears against the skin, so performers will forget they're wearing a mic. This version offers medium gain for very loud speaking, such as in theater performances and most vocals. In addition, the earset comes with three protective caps with different high-frequency response characteristics that control the amount of crispness or sibilance (response at 15 kHz). This omnidirectional E6 earset's cable terminates to a LEMO 6-pin connector for direct connection to Micron TX 700-Series wireless bodypack transmitters.

For Stage, Theater, and Broadcast TV    Fits Micron Transmitters    Headroom for Speaking and Vocals    Detachable 2mm Diameter Cable    Stiff, Steel Boom    Includes Windscreen    3 x Protective Caps    Black and White Single Tie Cable Clips    Carrying Case

The Countryman earsets are very small, lightweight, and the least visible headworn microphones.

The classic E6 is a good choice when one person will wear the microphone. Because the boom is stiffer, it can be adjusted to fit, then stored away and quickly reworn.

The E6's stainless steel boom is tough and can be bent and re-bent to fit different performers. It is highly resistant to makeup, sweat, and moisture when used with the supplied protective caps. The earset should always have a protective cap in place to keep sweat, makeup, and other foreign material out of the microphone.

The E6 earset's flexible boom is easily shaped right on the performer's face. Changeable protective caps let you shape the frequency response for different situations or to match other microphones. This omnidirectional version includes three protective caps—+4 dB (bright), +8 dB (very bright) and +0 dB (flat)—that controls the amount of crispness or sibilance (response at 15 kHz.)

Easy adjustment keeps the mic in a comfortable position for rejecting unwanted sounds. The omnidirectional E6 earset provides more isolation and is suitable for situations where there are loud monitors, extreme feedback, or environmental noise.

The included removable, quick-swap cable detaches from the actual earset, making it completely replaceable in the event of a short or break. The replaceable cable design makes upgrading wireless microphone systems easy as they are available in a wide selection of connections to accommodate most wireless transmitters.

Related Questions and Answers

Q: 1. Will this transmitter trigger strobes by brands other than Godox? I.e. Aperture and Westcott etc.

A: The Godox Xpro will only communicate with Godox X series receivers.

Q: 2. will the xProF work with a Fuji x-t3, Godox XiR C, and Canon 580 ex ii ?

A: Yes.

Q: 3. Can YN685 do HSS using Nikon D750?

A: also forget says I thinking getting one more flash YN685 I used with YN622 xmit I purchased two xmit each camera d610 and d750

Q: 4. Compatible with Nikon Speedlight SB-700? If yes, do I need anything else besides the Godox XPro for remote flash? I have a Nikon D750

A: The Godox X1R-N receiver, BH # GOX1RN is needed. https://bhpho.to/2LOILD4

Q: 5. Will this remote work with the Nikon z7ii?

A: Yes this is compatible with Nikon cameras like the Z7 II.

Q: 6. Can I control multiple (say 3) off camera YN-685s, with just using YN-622C-TX and without requiring all of them on YN-622C receiver?

A: You don't need the YN-622C receiver to control these flashes. They have the radio receivers built into the flash.

Q: 7. will this configuration work: XproS on a Sony A7rIV with Nikon SB5000 speed lights mounted to an X1RN?

A: It can be done for manual sync, but you wont have TTL, HSS or other advanced features.

Q: 8. system to Sony. Will this work with a Yongnuo 568EX, if I pair it with a X1r-S (shooting with a Sony A6500)?

A: No, that will not work. The flash needs to be for Sony with the multi-interface shoe.

Q: 9. What adapter will allow this to be mounted on Sony a37 with the older iISO shoe and still have full TTL/p-ADI functionality?

A: You are in luck. Here is the adapter, with TTL, that you are looking for. Vello HSA-CSASM Sony/Minolta to Sony Multi-Interface Shoe Adapter B&H # VEHSACSASM.

Q: 10. Is this compatible with the Godox R200?

A: The Godox R200 ringflash is an attachment for an AD200. The AD200 is compatible with this transmitter.