The Elite 52 x 92.4" Manual Series Front Projection Screen is a rugged screen for home, office, education, or business use. Whether wall or ceiling mounted, this screen will lock in any position by using the included pull cord. The viewing angle of 180° makes it viewable from just about anywhere in the room.

The surface generates a bright, clear, and vivid image with it's 1.1 gain. Behind the surface is a solid black backing material that prevents unwanted light bleed from contaminating the projected image. In addition, you can easily clean the screen with a mild soap and water solution.

Wall and Ceiling Mountable    Pull-Down Design    Non-Tensioned    106" Diagonal    HDTV Format    16:9 Aspect Ratio    MaxWhite Finish, 1.1 Gain    Front Projection

Screen lanyard allows the screen's pull-down handle to be reached from a high position

Black-backed screen material eliminates light penetration for superior color reproduction

Auto locking system provides variable height settings

180° wide viewing angle for commercial or home cinema

Optional 6, 12, and 18" hanging brackets available

Related Questions and Answers

Q: 1. Does this have a Slave Function with the Canon 600d ?

A: Yes, this flash can be used as a slave with the Canon 600D.

Q: 2. Can this be used on a Canon T5

A: Absolutely! In fact, the second set I purchased was cut into smaller shapes and distributed for use with flashes we have in the classroom. They work GREAT!

Q: 3. Is this compatible with Fuji xt-30?

A: Yes the X-T30 can work with this flash in manual mode.

Q: 4. Will the Yongnuo YN-560-IV work with my Fuji XT2?

A: I think those speed lights or meet for Canon cameras I bought them for my Sony camera and works fine but I am not sure if it will work with the Fuji

Q: 5. Does this work with manfrotto qr plates?

A: Not that we are aware of as this has a special plate with a top level that allows for front and back adjustments for better balance.

Q: 6. Is this compatible with canon R6 ?

A: Yes, the YN560-IV will work with the Canon EOS R6. It is a universal non-TTL-enabled flash, meaning it will be fully manual and trigger via the center pin (and via an off-shoe cord or wireless trigger if used off-camera).

Q: 7. To connect this with my sony a7S ii i have to by an additional transmitter or it comes with it?

A: the YN560 IV has a built in transmitter and receiver. It is a manual power adjustment only flash. If you want to use it off camera and remotely adjust power you will need either another YN560 IV or Yongnuo YN560-TX II Manual Flash Controller. Yongnuo makes them for Nikon and Canon. You can pick either one but will not get all the features that the dedicated units provide for the specific brands. For example, no remote zoom control. Also, the Sony multi-interface flash shoe is not exactly the same as the Canon and Nikon designs and proper alignment is sometimes difficult. Consider Godox TT600 Thinklite Flash for Sony Cameras and Godox X1T-S TTL Wireless Flash Trigger Transmitter for Sony as an alternative. These units offer same remote features but fit the Sony shoe properly.

Q: 8. Is this flash compatible with a Sony RX10 III?

A: no is not for sony

Q: 9. What is the maximum weight load?

A: This stabilizer has a payload between 1.1 to 6.6 pounds.

Q: 10. Is this works with old film cameras (like Nikon f3 & Mamiya 645 Pro) if I plugged the flash sync cable with it?

A: Yes, if you connect the flash via pc cable, it will work with your cameras.